Parts for Frigidaire FED355CCBC: 05 - Door Parts

Length: Approx. 82 1/2"

This refrigerator/freezer door gasket creates an airtight seal around the door to help maintain proper temperature and reduce energy use. It replaces a worn or damaged seal to improve cooling and reduce frost buildup. What it does:

• Seals the cabinet to keep cold air in and warm air out
• Helps prevent excess frost and moisture inside the compartment
• Reduces compressor run-time caused by air leaks
• Restores proper door alignment and consistent cooling

• Disconnect power and remove food from affected compartment before starting
• Remove the old gasket and thoroughly clean and dry the gasket channel before installing
• Press the new gasket into the channel evenly, starting at a corner and working around the door
• Check the seal by closing the door; adjust or reseat as needed for a uniform contact

Specs: 8 - 18 x 0.500

This is a #8 screw, 0.500 inch long, used to secure panels and components in appliances. It provides a correct-fit fastener for repairs where the original #8 x 1/2" screw was required, restoring proper assembly and stability. What it does:

• Fastens trim, panels, brackets and small components where a #8 x 1/2" screw is specified
• Holds parts securely to prevent rattling, gaps or loose panels
• Replaces worn, stripped or missing screws to restore proper fit
• Appropriate for common interior and exterior appliance mounting points

• Use the correct screwdriver (typically Phillips) and avoid over-tightening to prevent strip or damage
• Disconnect power and follow appliance manufacturer safety instructions when accessing internal parts

This is a replacement screw used to secure appliance panels and components. It restores proper fastening so panels, trim, or assemblies stay tight and reduce vibration or rattling. What it does

• Fastens panels, brackets, or trim to the appliance chassis
• Helps stop loose or vibrating panels and trim pieces
• Restores proper alignment where a missing or stripped screw causes gaps or movement
• Use when the original screw is missing, damaged, or corroded

• One replacement screw as shown

• Disconnect power to the appliance before starting any repair
• Use the correct screwdriver or bit to avoid stripping the screw head
• Tighten until snug; avoid over-torquing which can strip threads or crack plastic
• Keep removed screws in a safe place; this screw matches the original before installation