Parts for Frigidaire FFU09C2CW3: 03 - Door Parts

This door gasket seals the perimeter of the refrigerator or freezer door to maintain an airtight closure. Replacing a worn gasket restores a proper seal, helps stabilize temperatures, reduces frost and condensation, and supports efficient operation. What it does:

• Creates a tight seal between the door and cabinet to keep cold air in and warm air out
• Helps reduce frost buildup and moisture around the door opening
• Can address temperature fluctuations, long run times, and doors that won't fully close
• Replace if torn, deformed, brittle, or no longer sealing evenly

• 1 door gasket

• Disconnect power before servicing; open the door and remove the old gasket from its retainer/channel
• Warm the new gasket (soak in warm water) to relax and straighten before installation
• Seat the corners first, then work evenly around the perimeter to fully engage the retainer
• Close the door and check for uniform contact; adjust the gasket/retainer as needed for a complete seal

This outer door panel replaces a damaged or worn refrigerator door exterior to restore the appliance's appearance and protect internal components. It fits the refrigerator's front door and provides a finished surface for the handle and trim. What it does

• Replaces dented, scratched, or corroded exterior door surface to improve appearance.
• Restores a smooth mounting surface for the door handle and trim pieces.
• Protects internal door components from moisture and everyday wear.
• Helps maintain the door's intended fit and alignment when used with the correct inner components.

• One outer door panel

• Installation recommended; door panels often require door removal and precise alignment.
• Use proper tools to avoid scratching the new panel and to prevent damage to trim, seals, and hardware.
• Disconnect power to the appliance and remove perishable contents if door removal affects cooling.
• Refer to OEM instructions for torque specs and reassembly order.

Quantity of 1 clip.

Note: See kit# 5303922007 and 5304406520.

This is a gasket.

This replacement screw secures appliance components so brackets, shelves, trim, or panels stay firmly in place. Install a new screw when the original is missing, stripped, or corroded to restore a tight, rattle-free fit.

• Fastens brackets, panels, trim, or covers to the cabinet or liner
• Helps maintain alignment and reduce vibration and noise
• Direct replacement for a missing, rusted, or stripped fastener
• Use wherever your model's parts diagram specifies this screw

• Disconnect power before servicing; shut off water if working near water lines
• Match thread and length to the original location as shown in your model's parts diagram
• Start threads by hand to avoid cross-threading; tighten snugly without overtightening (especially into plastic)
• Retain and transfer any original spacers or clips used with this fastener