Parts for Frigidaire FRT13CRAW0: 02 - Door Parts

Color: White

The Freezer Door Gasket is an OEM part for Frigidaire refrigerators. This gasket creates a seal around the freezer door to prevent warm air from entering and cold air from escaping, ensuring the freezer maintains its optimal temperature.

Causes of a bad freezer door gasket can include wear and tear over time, exposure to harsh cleaning chemicals that degrade the material, or physical damage from frequent use or mishandling.

Symptoms of a bad freezer door gasket include:

• Noticeable gaps or cracks in the gasket
• Frost buildup inside the freezer
• Increased energy consumption
• The freezer door not closing properly

This OEM Frigidaire part is also compatible with Electrolux, Gibson, Kelvinator and some Kenmore models.

This refrigerator door gasket seals the fresh-food compartment to help maintain proper cooling and reduce energy loss. It restores a tight door seal to help keep food fresher and the refrigerator running efficiently. What it does:

• Replaces a worn, torn, or deformed door seal to stop cold air leakage
• Helps maintain consistent internal temperature and reduce frost buildup
• Reduces strain on the compressor caused by a poor door seal
• Addresses symptoms like warm spots near the door, excessive frosting, or higher energy use

• One refrigerator door gasket

• Remove power to the appliance before replacing the gasket
• Clean the door flange and allow it to dry before installing the new gasket
• Work around the full perimeter, easing the gasket into the channel; avoid forcing or trimming unless OEM instructions specify
• If the gasket is stiff, warm it gently (per OEM guidance) to aid fitting; avoid open flames or excessive heat

This inner door panel replaces the plastic interior liner that covers a refrigerator door, restoring a clean finish and proper support for door bins and hardware. It's a direct-fit OEM panel that repairs cracked, warped, or damaged door interiors. What it does:

• Restores the interior surface of the refrigerator door and provides mounting points for door bins and shelves
• Replaces cracked, split, or warped inner liners that can trap moisture or prevent proper door closure
• Secures door hardware and helps maintain a sealed, insulated door cavity
• Improves appearance by replacing scratched, stained, or discolored door interiors

• Disconnect power to the appliance before starting any repair
• Remove the door and any attached bins or hardware to access fasteners; save and reuse existing screws/clips unless damaged
• Handle panel edges carefully to avoid cracking; align clips or screw bosses and fasten snugly without over-torquing

Cut to fit design.

Rack is approximately 25 3/4" long. It may have to be cut for certain models.

For Right Hand Support. Color: white. It measures about 2 inches high by 2 inches deep. For Left Hand Support use part number 5303325991

For left hand support. Color: white. Measures about 2 inches high by 2 inches deep. For right hand support use part number 5303325990

Cut to fit design.

Color: White

Color: White

Size: Approximate 2.5 inches thick, 33 inches wide and 70 inches long.