Parts for Frigidaire GLEB27S7CBB: 07 - Door Parts

This spacer sets the correct gap between mating parts in your appliance's assembly, preventing rubbing and misalignment. Replace a missing or worn spacer to restore a solid fit, reduce noise, and protect surrounding components.

• Maintains proper spacing between components for correct alignment and operation
• Reduces metal-to-metal contact, squeaks, and premature wear
• Helps fasteners and panels seat securely
• Typical symptoms when failed: loose or rattling parts, uneven gaps, or visible wear marks

• Disconnect power; for gas models, shut off the gas. Allow the appliance to cool completely.
• Access the assembly per your model's diagram; note the original orientation/stack-up before removal.
• Reuse original fasteners if serviceable; hand-start threads and tighten snugly to avoid damaging the spacer.
• Verify alignment and clearances before fully reassembling. Quantity and location vary by model.

This split lockwasher helps keep screws and bolts secure by resisting loosening from vibration and thermal cycling, helping maintain stable connections in appliances. What it does:

• Fits around a fastener to provide spring tension that resists backing out
• Helps prevent loose panels, trim, or components that can rattle or shift
• Commonly used where vibration or temperature changes can loosen hardware
• Small replacement part that restores proper fastening retention

• One split lockwasher

• Use the correct washer size and orientation on the specified fastener
• Do not reuse a deformed washer; replace with the same style for reliable retention
• Avoid overtightening the fastener—tighten to secure snugness without crushing the washer
• Disconnect power and follow appliance-specific safety steps before accessing hardware

This is a #8 screw, 0.500 inch long, used to secure panels and components in appliances. It provides a correct-fit fastener for repairs where the original #8 x 1/2" screw was required, restoring proper assembly and stability. What it does:

• Fastens trim, panels, brackets and small components where a #8 x 1/2" screw is specified
• Holds parts securely to prevent rattling, gaps or loose panels
• Replaces worn, stripped or missing screws to restore proper fit
• Appropriate for common interior and exterior appliance mounting points

• Use the correct screwdriver (typically Phillips) and avoid over-tightening to prevent strip or damage
• Disconnect power and follow appliance manufacturer safety instructions when accessing internal parts