Parts for Ge DPVH890EJ2MV: 04 - Door Parts

Plastic plug that covers unused screw holes on dryer panels for a clean appearance. Replace when cracked, missing, or worn to protect openings.

The Door Latch is an OEM part for GE dryers. This part ensures the dryer door stays securely closed during operation, activating the safety switch to allow the dryer to operate. The latch mechanism engages with the door strike to lock the door, prevent

Dryer door gasket seal creates an air barrier around the door perimeter. Replace if worn, torn, or causing heat loss. Confirm fit with your model number.

Complete door hinge assembly that replaces a worn, damaged, or broken hinge. Restores proper door alignment and secure closing on your dryer.

Stainless steel #8 x 5/8" screw for dryer door and panel assembly. Replace missing, stripped, or corroded screws to secure components properly.

Replace stripped, missing, or damaged #8-32 x 1/2 machine screws that secure dryer panels, brackets, and internal components. Restores proper fit.

Left-side inner door cap for dryers. Replaces cracked, broken, or missing door trim caps. Installs on the interior edge of the dryer door panel.

Interior lining cap that shields insulation inside the dryer door opening. Replace if cracked, broken, or missing to restore proper door coverage.

This flat washer helps secure fasteners and distributes load to prevent damage where two parts join. It's a simple, durable replacement to restore proper fit and reduce movement at a bolted connection. What it does:

• Provides a flat bearing surface to spread pressure from nuts or bolts
• Helps prevent fasteners from digging into or deforming mating parts
• Reduces loosening from vibration or movement
• Can stop rubbing or binding that causes noise or premature wear

• One flat washer

• Power off and unplug the appliance before accessing internal components
• Replace the washer with an identical style and size to maintain fit and function
• Inspect mating fasteners and threads for damage; replace if worn
• Tighten fasteners to a snug fit—do not overtighten, which can cause distortion