Parts for Ge FCM9DMBWH: 01 - Door Parts

This door push-button light switch controls the interior lamp so the refrigerator light turns on and off when the door opens and closes. Simple, direct replacement to restore proper lamp operation and switch function. What it does:

• Activates the interior lamp when the door opens and turns it off when closed
• Replaces a worn, stuck, or non-responsive door push-button switch
• Helps stop lights that stay on, don't turn on, or flicker when the door is operated
• Restores reliable mechanical switching without changing the lamp or wiring

• One door push-button light switch

• Disconnect power to the appliance before beginning work
• Access typically requires removing the door lamp cover or inner door panel; keep screws and small parts organized
• Verify correct wiring connections and secure terminals; replace only with matching part

White freezer door handle attaches to the exterior door panel. Replace if your handle is cracked, broken, loose, or missing for secure door opening.

Replace a missing, stripped, or damaged 8-32 x 1/2 mounting screw in your freezer. Secures internal components and panels during assembly or repair.

Replace your freezer door gasket to restore a tight seal and prevent warm air leaks. Reduces frost buildup and energy waste. Confirm fit with your model number.

Panel clip secures interior panels in your freezer. Replace if panels are loose, rattling, or falling. Verify fit with your model number before ordering.

This snap-in plug button replaces a worn or missing plastic cover used to close unused openings or secure small wiring/plugs on the appliance. It restores a finished look and helps keep out dust and debris. What it does:

• Snaps into a corresponding hole or recess to cover an opening
• Helps prevent dirt, moisture, and small debris from entering service areas
• Restores a missing or damaged cosmetic cover for a clean appearance
• Can reduce rattles or movement where a loose opening exists

• Disconnect power to the appliance before working near electrical components.
• Typically installs by pressing into the matching opening until it snaps into place.
• Use a plastic tool or fingertip to avoid scratching surrounding surfaces.
• Inspect mounting area and replace any broken retainers before installing.

Wire harness assembly connecting lid and defrost components in your freezer. Replace if wires are damaged, frayed, or connections are loose or corroded.