Parts for Ge GFDS355EL1BB: 03 - Door Parts

This plastic screw plug covers and protects unused screw holes on appliance panels for a clean, finished look while helping keep out dirt and moisture. Simple replacement to restore appearance and prevent debris buildup. What it does:

• Covers exposed screw holes in trim or panels to improve appearance
• Helps block dust and light debris from entering through openings
• Prevents accidental contact with recessed screws
• Useful when replacing panels or removing components where plugs were lost

• One plastic screw plug

• Disconnect power or unplug the appliance before accessing internal panels when necessary
• Press the plug into the hole by hand; use a flat tool gently if alignment is tight
• Do not force or hammer the plug to avoid panel damage
• Replace any damaged surrounding trim before installing plug for a secure fit

The Door Latch is an OEM part for GE dryers. This part ensures the dryer door stays securely closed during operation, activating the safety switch to allow the dryer to operate. The latch mechanism engages with the door strike to lock the door, preventing it from opening while the dryer is running, which is essential for both safety and proper functioning of the appliance. 

Causes for replacement can include normal wear and tear, accidental damage, or a misalignment that prevents the door from securely latching. 

Symptoms of a bad Door Latch include:

• The dryer door doesn't stay closed during cycles.
• Difficulty in starting the dryer due to the door not activating the safety switch.
• Visible wear or damage to the latch mechanism.

This OEM GE part is also compatible with Hotpoint, RCA, and some Kenmore models.

The Gasket Seal is an OEM component specifically designed for GE dryers. It is a crucial sealing component that lines the perimeter of the dryer door. The gasket seal helps create an effective air barrier when the door is properly closed and secured.  

Causes of a bad gasket seal can include wear and tear resulting in cracks along the surface, deformities preventing flush contact with the door border, or material deterioration compromising its sealing abilities.

Symptoms of a bad gasket seal include:

• Excessively long drying cycles as air escapes around the compromised seal    
• Visible lint or debris collections where the gasket meets the door framing
• Noticeable drafts or air gaps discernible across the door perimeter

This OEM GE part is also compatible with Hotpoint, RCA, and some Kenmore models.

This hinge assembly kit replaces worn or broken door hinges to restore smooth opening and proper door alignment. It's a direct-fit hinge kit designed to support safe, reliable door movement and reduce sagging or binding. What it does:

• Replaces damaged or worn door hinge components for restored door support
• Helps correct door sag and misalignment that cause poor sealing or uneven gaps
• Reduces binding or sticking when opening and closing the door
• Restores proper hinge operation to prevent added strain on the door and cabinet

• Disconnect power to the appliance before starting any repair
• Follow the OEM instructions and use common hand tools for removal and installation
• Keep hands clear of pinch points; handle any attached door glass or trim carefully
• After installation, check door alignment and function; tighten fasteners to OEM torque where specified

This #8-32 x 1/2 machine screw is a direct-fit fastener used to secure panels and internal components in compatible appliances, restoring proper fit and eliminating loose or rattling parts. What it does:

• Secures panels, brackets, trim pieces and small internal assemblies where the factory screw is required
• Restores proper component alignment and prevents vibration-related noise
• Replaces missing or damaged mounting screws that allow parts to shift or come loose
• Matches standard #8-32 machine-thread fastener sizing commonly used in appliance assemblies

• Disconnect power and unplug the appliance before servicing to reduce shock risk
• Use the correct driver to avoid stripping the head; a magnetized screwdriver can help hold the screw
• Tighten until snug—do not overtighten to avoid damaging threads or panels
• Inspect mating threads and replace if damaged; replace with identical thread size and length