Parts for Ge GMR06AAPWW: 01 - Door Parts

A single M4 tapping screw used to secure panels and components on compatible appliances. This screw provides a reliable fastener for plastic and thin metal parts, helping restore proper fit and reduce vibration or rattling. What it does:

• Secures trim, control panels, brackets, and covers where a self-tapping fastener is required
• Replaces stripped or missing screws that cause loose panels or parts
• Restores proper alignment and reduces noise from vibrating components
• Designed to form threads in softer materials for a tight hold

• Use the correct M4 driver bit and steady pressure to start the screw straight
• Do not over-tighten; stop when the part is snug to avoid stripping or cracking
• Replace only with the same size and type of screw for proper fit and function
• Disconnect power before servicing appliances to reduce shock risk

This grommet-cap handle is a small replaceable trim piece that caps and cushions the end of a range/oven door handle for a finished look and secure fit. It helps keep the handle seated and reduces movement or rattling. What it does:

• Caps the exposed end of a door or handle for a clean, finished appearance
• Cushions and secures the handle to prevent looseness or wobble
• Helps keep handle trim aligned and reduces vibration noise
• Restores a worn or cracked end piece that can detract from the appliance's appearance

• Disconnect power to the appliance or follow manufacturer safety guidance before servicing
• Typically installs by pressing into the handle end; handle removal may be required on some models
• Inspect surrounding trim and fasteners; replace any damaged clips or screws
• Do not force the part; if it does not seat easily, check orientation and mounting surfaces

This door grommet is a small rubber push-in cushion that protects and cushions the appliance door where it contacts the cabinet. It helps prevent metal-on-metal wear and reduces rattling for a quieter, smoother door operation. What it does:

• Cushions door contact points to prevent scratching and wear
• Dampens vibration and reduces door rattle or noise
• Helps maintain proper door alignment at the contact area
• Simple, passive part—no wiring or electronics

• One door grommet

• High-level DIY: remove the old grommet and press the new grommet into the existing hole or slot until fully seated
• Unplug or disconnect power to the appliance before performing any service that requires moving the door
• Avoid using sharp tools that can damage the grommet or surrounding trim; trim edges may be needed for tight fits
• If grommet mounts behind a gasket or trim, remove that trim first following the appliance manufacturer's instructions