Parts for Ge ZDOD240PBSS: 01 - Door Parts

This hinge fill plug is a small door-hinge cover that restores a finished appearance and helps keep debris and moisture out of the hinge area. It's a simple cosmetic and protective replacement for worn or missing hinge caps. What it does:

• Covers and protects the door hinge opening to limit dirt and moisture buildup
• Restores the cabinet's finished look where a hinge cap is missing or damaged
• Helps keep hinge components cleaner for smoother door movement
• Matches OEM fit and form for a direct replacement

• One hinge fill plug (single replacement piece)

• High-level, no-specialty tools required for most installs; door support may be needed
• Remove old plug by gently prying; press new plug into place until seated
• If hinge fasteners are exposed, support the door before removing hardware to prevent dropping
• Follow basic safety: unplug appliance if working near electrical components and wear gloves/eye protection as needed

This magnetic refrigerator door gasket creates a tight seal to help keep cold air inside and reduce energy waste. It replaces a worn or damaged seal to restore proper door closure and improve temperature stability. What it does:

• Seals the fridge/freezer door edge so cold air stays inside and warm air stays out
• Helps prevent frost buildup and temperature fluctuations caused by leaks
• Reduces the compressor running time that results from a poor seal
• Restores proper magnetic latch and improves overall door alignment

• One replacement magnetic door gasket

• Disconnect power before starting and remove food from the door area for easy access
• Clean and dry the gasket channel before installing to ensure a good seal
• Press the gasket evenly into the channel, working around the door to seat magnets fully
• Inspect the door alignment and hinge condition; replace hardware if the door does not sit squarely

A small adhesive MG logo emblem that restores the original appearance of your appliance. This peel-and-stick badge replaces a worn, faded or missing logo to keep the exterior looking factory-fresh. What it does:

• Cosmetic replacement for a missing, scratched or faded MG emblem
• Adheres to control panels, doors or trim where the original badge was located
• Restores brand identification and a finished appearance to the appliance
• Simple adhesive design avoids the need for fasteners or tools

• Clean and dry the mounting surface before applying to ensure good adhesion
• Peel backing and press firmly in place, aligning carefully before contact
• Avoid repositioning once attached; removal may damage the emblem or finish
• For safety, disconnect power before working near electrical controls or panels

This handle tube assembly replaces a damaged or worn door handle tube to restore a secure grip and clean appearance. It installs on compatible refrigerator/freezer doors and brings back smooth door operation and safe handling. What it does:

• Provides the structural tube for the door handle so you can open and close the door securely
• Replaces cracked, bent, loose, or visibly damaged handle tubes
• Stops wobbling or detached handles caused by a failed tube assembly
• Restores proper fit and appearance of the door handle area

• Disconnect power to the appliance and empty the door area before starting work when applicable
• Remove door trim or screws as needed to access the handle tube per your model's service instructions
• Install using the original fasteners; verify proper alignment and secure fit before regular use