Parts for Ge ZIBI240PCII: 01 - Door Parts

This magnetic refrigerator door gasket creates a tight seal to help keep cold air inside and reduce energy waste. It replaces a worn or damaged seal to restore proper door closure and improve temperature stability. What it does:

• Seals the fridge/freezer door edge so cold air stays inside and warm air stays out
• Helps prevent frost buildup and temperature fluctuations caused by leaks
• Reduces the compressor running time that results from a poor seal
• Restores proper magnetic latch and improves overall door alignment

• One replacement magnetic door gasket

• Disconnect power before starting and remove food from the door area for easy access
• Clean and dry the gasket channel before installing to ensure a good seal
• Press the gasket evenly into the channel, working around the door to seat magnets fully
• Inspect the door alignment and hinge condition; replace hardware if the door does not sit squarely

A small adhesive MG logo emblem that restores the original appearance of your appliance. This peel-and-stick badge replaces a worn, faded or missing logo to keep the exterior looking factory-fresh. What it does:

• Cosmetic replacement for a missing, scratched or faded MG emblem
• Adheres to control panels, doors or trim where the original badge was located
• Restores brand identification and a finished appearance to the appliance
• Simple adhesive design avoids the need for fasteners or tools

• Clean and dry the mounting surface before applying to ensure good adhesion
• Peel backing and press firmly in place, aligning carefully before contact
• Avoid repositioning once attached; removal may damage the emblem or finish
• For safety, disconnect power before working near electrical controls or panels