Parts for Ge ZIFI240PBLII: 01 - Door Parts

This magnetic refrigerator door gasket creates a tight seal to help keep cold air inside and reduce energy waste. It replaces a worn or damaged seal to restore proper door closure and improve temperature stability. What it does:

• Seals the fridge/freezer door edge so cold air stays inside and warm air stays out
• Helps prevent frost buildup and temperature fluctuations caused by leaks
• Reduces the compressor running time that results from a poor seal
• Restores proper magnetic latch and improves overall door alignment

• One replacement magnetic door gasket

• Disconnect power before starting and remove food from the door area for easy access
• Clean and dry the gasket channel before installing to ensure a good seal
• Press the gasket evenly into the channel, working around the door to seat magnets fully
• Inspect the door alignment and hinge condition; replace hardware if the door does not sit squarely

This lower door profile is a trim piece that restores the bottom edge of the refrigerator/freezer door for a clean appearance and proper fit. It replaces a cracked, dented, or missing lower door trim to help maintain door alignment and appearance. What it does:

• Covers and protects the lower edge of the door from impact and wear
• Restores proper fit where cracked or broken trim causes gaps or visible damage
• Helps maintain door appearance and prevents dirt buildup in the door edge
• Works with existing door hardware and seals to support normal door operation

• Disconnect power to the appliance before starting repairs
• Remove the door or lay it flat per the manufacturer's service instructions if needed
• Typically installed with clips or screws; keep fasteners and alignment points aligned during reassembly

A small adhesive MG logo emblem that restores the original appearance of your appliance. This peel-and-stick badge replaces a worn, faded or missing logo to keep the exterior looking factory-fresh. What it does:

• Cosmetic replacement for a missing, scratched or faded MG emblem
• Adheres to control panels, doors or trim where the original badge was located
• Restores brand identification and a finished appearance to the appliance
• Simple adhesive design avoids the need for fasteners or tools

• Clean and dry the mounting surface before applying to ensure good adhesion
• Peel backing and press firmly in place, aligning carefully before contact
• Avoid repositioning once attached; removal may damage the emblem or finish
• For safety, disconnect power before working near electrical controls or panels

This upper door profile is the trim piece that restores the top edge of the refrigerator door for a finished look and proper fit. It replaces cracked, warped or missing top door molding to improve appearance and door alignment. What it does

• Replaces the upper trim/molding that caps the top edge of the refrigerator door
• Restores a flush, finished edge and helps maintain correct door fit
• Stops rattling or gaps caused by damaged or broken trim
• Improves cosmetic appearance of the door

• One upper door profile trim piece

• Disconnect power to the appliance before beginning any work
• Remove door liners or inner trim as needed to access mounting points; retain fasteners
• Install by aligning profile and securing with the original clips or screws; do not force or bend the trim
• If plastic fragments or sharp edges are present, wear gloves and dispose of broken pieces safely