Parts for Ge ZIRS36NMALH: 01 - Door Parts

Truss head screw (#10-32 x 3/4) secures panels, brackets, and trim on freezers and refrigerators. Replace missing or stripped screws to restore stability.

Bottom door hinge screw secures the lower hinge assembly to your refrigerator door. Replace if stripped, missing, or damaged to restore door alignment.

Replace your refrigerator's dairy door and tray assembly if cracked, broken, or missing. This component installs on the inner door to organize dairy products.

Refrigerator door hinge stop and nut assembly. Installs on the door hinge to control door swing and positioning. Replace if cracked, broken, or missing.

Mounting hardware kit that secures trim panels and components on freezers and refrigerators. Replace if standoffs are broken, missing, or causing loose trim.

White door bin shelf for refrigerator interior door storage. Replace cracked, broken, or missing door bins. Slides into place for quick installation.

Deep door bin mounts to the right side of your refrigerator door for tall container storage. Replace cracked, broken, or missing bins to restore space.

White plastic door bin for refrigerator door storage. Replace cracked, broken, or missing bins to restore door organization and prevent spills.

Set of #10-32 thread screws for securing refrigerator panels and internal components. Replace missing, stripped, or damaged fasteners to eliminate loose parts.

This is a refrigerator handle kit. This kit includes one handle that has a stainless steel finish. The purpose of the handle is to provide a piece to hold onto to open the refrigerator door. The handle could become damaged if it comes into forceful impact with another object. It can become dented or scratched. If the stainless steel finish begins to wear over time, this part will be a high-quality replacement. Save the screws from the original handle to install the one one. Replacing this part is very easy and can be done quickly by following the installation instructions. Some people may wish to wear work gloves to protect their hands during the replacement process.This specific handle kit is compatible with refrigerator units that are manufactured by the General Electric brand, including Hotpoint and RCA. It is sold individually and is sourced directly from the manufacturer.

This pack contains twelve replacement screws used to fasten appliance panels, trim, and components. They restore secure mounting and help stop rattling, loose panels, and gaps for a safer, quieter appliance. What it does:

• Secures exterior and interior panels, brackets, and trim pieces
• Restores proper fit where missing or stripped screws cause movement or noise
• Helps maintain appliance alignment and prevents parts from vibrating loose
• Used for general-purpose repairs on compatible GE appliances

• Disconnect power or unplug the appliance before performing any internal repairs
• Use the correct screwdriver bit and avoid overtightening to prevent stripping threads
• Keep remaining screws in a labeled container for future service
• If a screw does not seat easily, stop and verify correct fit to avoid damage

Replace your refrigerator's door hinge to restore proper door alignment and operation. Needed when the existing hinge is cracked, broken, or worn out.

This refrigerator door gasket creates a tight, reliable seal between the door and cabinet. Replacing a worn gasket helps keep cold air in, block warm, humid air, and restore proper temperatures and efficiency.

• Forms an airtight seal around the door perimeter to maintain correct internal temperatures
• Helps reduce frost, condensation, and energy use caused by air leaks
• Resolves poor sealing from tears, warping, cracks, or compression set
• Can help with symptoms like doors not closing fully or popping open and warm spots near the door

• Unplug the refrigerator and clear items from the door before service
• Warm the new gasket in hot water or with low, indirect heat to relax and shape it
• Remove the old gasket from the retaining channel; press the new gasket in place starting at the corners and working evenly around
• Use gentle heat to eliminate gaps and ensure a consistent seal