Parts for Ge ZSC2000FBB02: 01 - Door Parts

A small rubber buffer that cushions moving parts to reduce noise, vibration and metal-on-metal contact. Replacing a worn cushion restores quieter operation and helps prevent damage to adjacent components. What it does:

• Absorbs shock and dampens vibration from doors, panels or moving assemblies
• Reduces rattling, squeaks and intermittent contact noises
• Protects metal parts from wear where components contact or rest
• Keeps assemblies aligned by providing a small, supportive stop

• One rubber cushion as shown

• Disconnect power to the appliance before servicing
• Remove any trim or panels needed to access the cushion location
• Press or seat the cushion into its mounting slot or onto the mating surface; replace fasteners if applicable
• Inspect surrounding parts for wear and replace any damaged retainers or adhesives

Teflon washer for microwaves. Installs between mounting surfaces to reduce friction and prevent wear. Replace if cracked, damaged, or missing.

Mounting support plate that secures the control panel assembly in your microwave. Replace if cracked, warped, or broken to restore proper alignment.

Protector pin for microwave interior assembly. Replaces broken, missing, or damaged pins. Structural component for secure mounting and alignment.

A small suspension spring retainer that secures a washer's suspension spring to the tub or cabinet, keeping the spring seated so the tub stays stable during spin cycles. What it does

• Holds the suspension spring in place so the tub remains properly supported
• Prevents the spring from slipping off during agitation or spin
• Helps reduce excessive tub movement, banging, and off-balance symptoms
• Works with the washer's spring and mounting stud to maintain correct suspension

• One spring lock / suspension spring retainer

• Disconnect power and water before beginning any repair
• Support the tub or cabinet when removing or reinstalling suspension springs to avoid sudden drops
• Inspect springs and mounting studs; replace any worn or damaged components to ensure proper function
• Use basic hand tools; follow manufacturer service instructions for safe reassembly

This handle assembly replaces a worn or broken oven door handle so you can open and close the oven safely and with a secure grip. It restores proper door operation and appearance without replacing the entire door. What it does:

• Replaces a cracked, loose or missing oven door handle that feels unstable or wobbly
• Provides a secure grip for opening and closing the oven door
• Helps maintain proper door alignment and sealing during use
• Restores the original look of the appliance's front

• Disconnect power to the appliance before starting any repair to avoid shock or injury
• Handle typically mounts with screws from the interior of the door; remove the inner door panel if necessary
• Use the proper size screwdriver; align the handle and tighten screws evenly without over-torquing

Plastic choke cover that fits around the microwave door perimeter. Replace if cracked, broken, or missing to restore proper door seal appearance.

Five-pack of installation screws for securing microwave components and mounting brackets. Replace missing, stripped, or corroded screws during repair.