Parts for Kitchenaid KBCO24LSBX04: 03 - Door Parts

This flat washer is a small hardware fastener used to distribute load and keep screws or bolts secure. It helps maintain tight connections and prevents damage to appliance surfaces where fasteners pass through. What it does:

• Provides a smooth bearing surface for screws or bolts to reduce wear
• Helps distribute load to prevent fastener pull-through or material deformation
• Reduces loosening from vibration that can cause rattling or misalignment
• Commonly used where a secure, flush fastener connection is required

• One flat washer

• Disconnect power and water to the appliance and follow basic electrical and safety precautions before replacing hardware
• Use the washer with the matching screw or bolt size and material specified by the manufacturer
• Inspect mating surfaces and replace any damaged fasteners or parts to ensure a secure fit

The Gasket is an OEM part for Whirlpool refrigerators. This gasket is designed to create an airtight seal around the refrigerator or freezer door, preventing warm air from entering and cold air from escaping. It helps maintain the internal temperature, ensuring efficient operation and food preservation.

Causes of a bad gasket can include wear and tear over time, damage from frequent opening and closing of the door, or buildup of dirt and grime that compromises the seal.

Symptoms of a bad gasket include:

• The door not sealing properly
• Increased frost buildup in the freezer
• Higher energy bills due to the refrigerator working harder
• Condensation or moisture around the door seal

This OEM part is also compatible with Maytag, KitchenAid, Jenn-Air, Amana, Magic Chef, Admiral, Norge, Roper, and Kenmore models.

Factory replacement screw that secures appliance components and hardware. Use it to replace a missing, stripped, or corroded fastener to restore a tight, rattle-free fit and help prevent loosening or damage from vibration.

• Fastens brackets, panels, or internal parts at the original mounting points
• Replaces worn or missing hardware to correct loose or misaligned components
• Helps reduce vibration-related noise and movement
• Matches the original thread and length specified for the application

• Disconnect power; shut off water or gas if applicable before servicing
• Compare to the original for thread and length match before installation
• Start threads by hand to avoid cross-threading; tighten snugly—do not overtighten
• Reuse any original spacers/washers if present; replace if damaged