Parts for Maytag AMV2175CB0: 02 - Door Parts

A white replacement door handle that restores a usable grip and appearance to your appliance door. Ideal when the original handle is cracked, loose, or missing so the door can be opened and closed reliably. What it does:

• Provides a secure grip for opening and closing the appliance door.
• Replaces cracked, broken, loose or missing handles that make the door difficult to operate.
• Matches original mounting points for a direct-fit replacement.
• Restores the door's finished appearance and basic function.

• Disconnect power (and water, if applicable) before beginning any repair.
• Access the handle mounting screws by opening/removing the door panel per the OEM service instructions.
• Use basic hand tools and retain all original fasteners and trim for reassembly.

This genuine replacement door handle restores a secure grip and smooth operation to your appliance door. It replaces a worn, cracked, or broken handle so you can open and close the door safely and comfortably. What it does:

• Provides a sturdy handhold for opening and closing the appliance door
• Replaces cracked, loose, or broken handles that cause difficulty operating the door
• Restores proper alignment and fit where the original handle has worn or failed
• Helps reduce accidental slippage or dropping of the door during use

• One door handle

• Handle requires basic hand tools for removal and installation; refer to your model's service instructions
• Keep the appliance unplugged or power disconnected when working near electrical components
• Tighten mounting fasteners securely but avoid over-torquing to prevent cracking
• If the handle mounts to an inner door panel or trim, support the door edge to avoid damage during installation

This replacement screw secures appliance components such as panels, brackets, and covers. Replace a missing or stripped fastener to restore a tight, rattle-free fit and proper alignment. What it does:

• Secures panels, brackets, trim, and internal assemblies in place
• Replaces lost, corroded, or stripped hardware
• Helps reduce vibration and rattling from loose components
• Maintains correct fit and alignment of covers and parts

• One screw

• Disconnect power before servicing; wear appropriate safety gear
• Match the screw to the original location; transfer any washers or clips from the old hardware
• Start threading by hand to avoid cross-threading; tighten snugly without overtightening
• Repair damaged receiving threads before installing the new fastener

This handle base secures the exterior handle to the appliance door or drawer and covers the mounting point. Replacing a cracked or stripped base restores a solid, aligned handle and a clean, finished look.

• Anchors the handle to the door/drawer and provides a stable mounting point
• Helps keep the handle straight and tight during use
• Covers mounting hardware for a finished appearance
• Addresses issues like a loose or wobbly handle, broken/missing base, or stripped mounting threads

• Disconnect power to the appliance before servicing
• Remove the handle by loosening set screw(s) or mounting screws, then remove the old base
• Position and fasten the new base; transfer/reuse existing screws if applicable
• Reinstall the handle and tighten securely without overtightening; verify alignment and operation