Parts for Whirlpool EV250NXTQ02: 04 - Door Parts

This vent plug seals the designated vent port on the appliance assembly to maintain the intended seal and containment. Replacing a worn or missing plug helps prevent nuisance leaks and odors from an open or damaged vent.

• Seals a factory vent opening on the specified assembly
• Helps prevent moisture or drips from escaping at the vent area
• Helps keep dust and debris from entering through an open port
• Replace if the plug is cracked, hardened, shrunken, loose, or missing
• Typical signs include moisture around the vent, visible damage, or a plug that won't stay seated

• Disconnect power and shut off water or gas supplies (as applicable) before servicing
• Allow appliance surfaces to cool and dry; wear protective gloves
• Remove the old plug, clean the vent port, and press the new plug fully flush in the same orientation
• Restore power and run a brief test; inspect the vent area for leaks

This refrigerator door gasket creates an airtight barrier between the door and cabinet. A proper seal keeps cold air in and humid air out to maintain temperature, reduce frost, and support efficient operation.

• Seals the door perimeter to prevent air leaks
• Helps maintain stable temperatures and reduce condensation/frost
• Restores smooth door closing and even contact around the frame
• Typical failure signs: tears, warping, gaps, moisture or frost near the door, longer run times

• Disconnect power before servicing
• Let the new gasket relax in warm water or gently warm with a hair dryer on low to make it pliable
• Remove the old gasket from its channel or from under the inner-liner retainer; press the new gasket fully into place, seating corners first and reusing existing fasteners if present
• Close the door to check for uniform contact; adjust retainer/hinges as needed and allow up to 24 hours for the seal to fully conform

Color: Grey

This door stop replaces the worn or broken stop that limits door travel and keeps the door aligned for smooth opening and closing. Restores proper door positioning to prevent over-travel and edge wear. What it does:

• Acts as the mechanical stop that limits the door's range of motion
• Helps keep the door aligned and prevents the door from swinging past the designed stop
• Reduces stress on hinges and adjacent trim from over-travel
• Commonly replaced when the door binds, catches, or does not sit flush

What's included:

• One door stop (stop-door) as shown

Install notes:

• Disconnect power and follow the appliance manufacturer's safety instructions before servicing
• Removal typically requires basic hand tools; keep fasteners for reassembly
• Inspect surrounding hinge and trim for wear; replace as needed