Parts for Whirlpool GH7208XRB3: 02 - Door Parts

This is a genuine replacement screw used to fasten appliance panels, trim, and components. It restores secure attachment and helps eliminate rattles or loose parts for safe, reliable operation. What it does:

• Secures panels, brackets, trim pieces, or internal components
• Stops vibration-related noise caused by loose or missing fasteners
• Restores proper alignment and fit of assembled parts
• Provides the correct thread and length for the intended factory location

• One screw

• Use the correct screwdriver or bit to avoid stripping the head
• Hand-start the screw to ensure correct thread engagement before final tightening
• Tighten until snug; avoid over-tightening which can strip threads or crack plastic
• Disconnect power to the appliance before working in areas near electrical components

This replacement screw is a general-purpose fastener used to secure exterior panels, trim, or internal components on compatible Whirlpool appliances. It restores proper fit and reduces rattles or loose parts for a safer, more reliable appliance. What it does:

• Secures panels, trim pieces, or mounting brackets to keep components in place
• Prevents vibration-related noise and movement caused by missing or loose fasteners
• Helps maintain alignment of control panels and exterior housings
• Replaces stripped, corroded, or lost screws to restore original fit

• Use the correct screwdriver or bit to avoid stripping the head
• Match screw length and thread engagement with the original for a secure fit
• Tighten to snug only; over-tightening can strip threads or crack panels
• Disconnect power before performing repairs on electrical components

This factory fastener replaces a worn or missing screw to securely hold appliance components in place. Use it to restore a tight, rattle-free fit so panels, brackets, or assemblies stay properly aligned during everyday use.

• Secures panels, brackets, or internal components
• Helps correct loose, rattling, or misaligned parts
• Useful when a screw is stripped, corroded, or missing
• Maintains proper fit and stability after service

• Disconnect power and shut off water supply before service
• Match the original screw location and orientation; replace like-for-like
• Start threads by hand to avoid cross-threading; do not overtighten
• If threads are damaged, repair or replace the receiving clip/insert