Parts for Ge ZIDS240PBSS: 01 - Doors & Controls Parts

A small adhesive MG logo emblem that restores the original appearance of your appliance. This peel-and-stick badge replaces a worn, faded or missing logo to keep the exterior looking factory-fresh. What it does:

• Cosmetic replacement for a missing, scratched or faded MG emblem
• Adheres to control panels, doors or trim where the original badge was located
• Restores brand identification and a finished appearance to the appliance
• Simple adhesive design avoids the need for fasteners or tools

• Clean and dry the mounting surface before applying to ensure good adhesion
• Peel backing and press firmly in place, aligning carefully before contact
• Avoid repositioning once attached; removal may damage the emblem or finish
• For safety, disconnect power before working near electrical controls or panels

This control board assembly manages appliance functions and user interface signals so your appliance responds correctly to settings and commands. Replacing a faulty board restores electronic control and reliable operation. What it does:

• Receives input from buttons/controls and sends signals to actuators, valves, and motors
• Regulates timed cycles and mode selections for normal operation
• Can cause unresponsive controls, no cycle starts, or incorrect cycle behavior when failed
• May show symptoms like unlit or erratic display, intermittent operation, or no power to controlled components

• One control board assembly

• Disconnect power before starting; ensure the appliance is fully de-energized
• Handle the board by edges and avoid electrostatic discharge; use an ESD strap if available
• Compare the replacement with the original board and note connector locations before unplugging
• Secure all connectors and mounting fasteners; test basic functions after reassembly

This lower refrigerator drawer door replaces a cracked, warped, or damaged drawer front to restore a clean seal and smooth opening. It's a direct-fit exterior drawer front designed for a proper closure and appearance. What it does:

• Serves as the front panel for the lower storage/drawer compartment, providing a handle surface and sealing edge.
• Restores a tight closure to help maintain internal temperatures when the drawer is closed.
• Replaces visibly damaged, cracked, or warped drawer fronts to improve function and aesthetics.
• Works with existing drawer glides, tracks, and hardware when those components are undamaged.

• 1 drawer door lower (drawer front)

• Remove power or follow manufacturer safety instructions for accessing the drawer area before starting.
• Installation typically requires removal of the drawer from its tracks; handle hardware or trim may need to be transferred.
• Inspect mounting clips, screws, and tracks for wear and replace as needed.