Parts for Ge GTE16DTHPRWW: Doors Parts

This service common handle replaces a worn or broken handle to restore safe, reliable operation and improve the appliance's usability. It provides a direct-fit replacement for the original service handle. What it does

• Replaces a damaged or broken service handle so doors/panels can be opened and closed securely
• Restores proper grip and alignment for normal use
• Helps eliminate rattling or loose-handle symptoms caused by wear or damage
• Matches factory fit to maintain intended operation

• One service common handle (quantity: 1)

• Basic hand tools typically required; disconnect power or follow appliance-specific safety steps before starting
• Inspect mounting area and hardware; reuse or replace fasteners as needed
• Do not force parts; ensure correct alignment to avoid damaging mating components

Replacement freezer door shelf support bar for refrigerators. Holds door bins and shelves in place. Replace if cracked, broken, or warped plastic causes shelving to sag.

Freezer door gasket creates an airtight seal to keep cold air in and warm air out. Replace if torn, cracked, or not sealing properly. Confirm fit.

White plastic bumper that cushions freezer door travel and prevents slamming. Replace if cracked, broken, or missing to restore proper door positioning.

White plastic door stop cushions and limits refrigerator door swing. Installs on cabinet to prevent over-travel damage. Replace if cracked or missing.

White door gasket creates an airtight seal to keep cold air in. Replace if torn, loose, or causing frost buildup. Verify fit with your model number.

Clear snap-in dairy door bin for refrigerator compartments. Replace if cracked, broken, or missing to organize and separate dairy items in door storage.

Replace a broken, cracked, or missing door shelf rail on your refrigerator. This rail secures items on door shelves, preventing them from falling out.

Reversible door plug fills unused mounting holes when switching refrigerator door swing direction. Replaces broken or missing plugs for a finished look.

Mounting hardware kit that secures refrigerator or freezer door handles. Restores solid grip when original fasteners are missing, damaged, or stripped.

This plug button is a small snap-in cap used on refrigerators to cover exposed holes on door handles, liners, or trim. It restores a clean, finished look while helping keep dust and moisture out of the cabinet.

• Snaps into a screw or access hole on a handle, liner, or trim panel
• Covers fasteners and gaps for a clean, finished appearance
• Helps block dirt and moisture from open holes
• Typical symptoms: missing cap, broken or loose plug, visible screw hole or cosmetic gap

• Unplug the appliance before servicing and use caution around sharp edges
• Align the plug with the hole and press straight in by hand until fully seated and flush
• For handle screw holes, tighten fasteners first, then install the cap
• Avoid using metal tools on finished surfaces to prevent scratches

Secure refrigerator panels, handles, shelves, and internal components with this mounting screw. Replace worn, stripped, or missing screws easily.