Parts for Ge CT9070SH3SS: Doors Parts

Decorative badge assembly that mounts on the front of your range. Displays brand and model information. Replace if cracked, peeling, or missing.

Center seal for electric ranges and wall ovens. Prevents heat loss and ensures proper cooking temperature. Replace if damaged, cracked, or worn. Confirm fit with your model number before ordering.

This handle and end cap assembly replaces a damaged or worn door handle and protective end cap to restore a secure grip and finished appearance. It fits the appliance's front door and installs without changing the door structure. What it does:

• Provides a sturdy replacement handle for opening and closing the appliance door
• Replaces a cracked, loose, or broken handle end cap for a clean finish
• Restores proper grip and prevents sharp edges or further damage
• Helps the door operate normally when original handle hardware has failed

• Disconnect power (and gas supply if applicable) before starting any repair
• Basic hand tools required; avoid force when removing or installing to prevent finish damage
• Keep all fasteners and alignment features; install per manufacturer instructions

Mounting screw secures panels, trim, and internal components in ranges and ovens. Replace if missing, stripped, or damaged to restore proper fit.

Secures the hinge cover to your refrigerator door or cabinet hinge. Replace this screw if it's missing, stripped, or damaged to stop the cover from loosening.

A single #8-18, 1/2-inch screw used to secure interior and exterior appliance panels and components. Replaces a worn or missing fastener to restore secure mounting and reduce rattles or loose parts. What it does:

• Fastens panels, trim, brackets, and small components where a #8-18, 1/2" screw is required
• Replaces missing or stripped screws that cause loose panels or vibration noise
• Provides a proper threaded connection for reliable mechanical support
• Matches common OEM panel and trim fastening points

• Unplug the appliance or shut off power before starting any repair
• Use the correct screwdriver or bit to avoid stripping the head
• Tighten securely but avoid over-tightening, which can strip threads or crack panels
• If thread engagement is damaged, replace the mating fastener or insert as needed