Parts for Ge CT9070SH4SS: Doors Parts

The Badge Assembly is an OEM part for GE ranges. It includes the magnetic decorative badge affixed to the front of the range. This badge displays important information such as the brand name, model number, and technical specifications.

Causes of a bad badge assembly can include damage from impacts or abrasions over time, adhesive failure from repeated heat exposure, or normal wear from routine cleaning. On a range, the badge must withstand higher cooking temperatures.

Symptoms of a bad badge assembly include:

• Faded or illegible print on the badge face
• Cracks or breaks in the plastic material
• The badge lifting or peeling away from the surface
• Missing or loose attachment clips/fasteners

This OEM GE part is also compatible with Hotpoint, RCA, and some Kenmore models.

This handle and end cap assembly replaces a damaged or worn door handle and protective end cap to restore a secure grip and finished appearance. It fits the appliance's front door and installs without changing the door structure. What it does:

• Provides a sturdy replacement handle for opening and closing the appliance door
• Replaces a cracked, loose, or broken handle end cap for a clean finish
• Restores proper grip and prevents sharp edges or further damage
• Helps the door operate normally when original handle hardware has failed

• Disconnect power (and gas supply if applicable) before starting any repair
• Basic hand tools required; avoid force when removing or installing to prevent finish damage
• Keep all fasteners and alignment features; install per manufacturer instructions

This SCR (silicon controlled rectifier) is a replacement power-regulation semiconductor used in select GE appliances to control voltage to heating elements or motors, restoring reliable variable power control and stable operation. What it does

• Regulates and switches power to heating elements or drive motors as part of the appliance's control circuitry.
• Helps maintain consistent heat or motor speed when the control board calls for variable output.
• Can resolve symptoms such as intermittent heating, fluctuating motor speed, or appliances that run only on certain settings.
• Functions as a direct electrical switching component—not a user-serviceable interface.

• One SCR (silicon controlled rectifier) matching OEM part WB01X24096.

• Always disconnect power at the breaker or unplug the appliance before starting any repair.
• Handle the part carefully; observe anti-static precautions and avoid touching leads or terminals.
• Verify the part number on the old component matches WB01X24096 before installation.

This 8-32 machine screw (7/16") is a painted fastener used to secure panels, brackets, and components on compatible appliances. It replaces missing or worn screws to restore proper fit and reduce vibration. What it does:

• Secures panels, control assemblies, brackets, and small hardware
• Restores proper alignment and prevents rattling or loose parts
• Used where an 8-32 thread and 7/16" length are required
• Painted finish matches appliance surfaces and resists corrosion

• One painted 8-32 machine screw, 7/16" length

• Unplug the appliance before servicing to avoid shock or injury
• Use the correct screwdriver or nut driver to avoid stripping the head
• Install by hand to start threads, then tighten snugly—do not overtighten
• Keep track of small parts during disassembly; magnetic trays help prevent loss

A single #8-18, 1/2-inch screw used to secure interior and exterior appliance panels and components. Replaces a worn or missing fastener to restore secure mounting and reduce rattles or loose parts. What it does:

• Fastens panels, trim, brackets, and small components where a #8-18, 1/2" screw is required
• Replaces missing or stripped screws that cause loose panels or vibration noise
• Provides a proper threaded connection for reliable mechanical support
• Matches common OEM panel and trim fastening points

• Unplug the appliance or shut off power before starting any repair
• Use the correct screwdriver or bit to avoid stripping the head
• Tighten securely but avoid over-tightening, which can strip threads or crack panels
• If thread engagement is damaged, replace the mating fastener or insert as needed