Parts for Ge GBE20ETEARBB: Doors Parts

Color: Black

This stop door is the replacement dispenser flap that opens to let ice or water out and seals the dispenser chute when idle to help keep cold air and moisture inside. A simple swap restores proper dispenser operation. What it does:

• Opens and closes the dispenser chute so ice or water dispenses only when activated
• Seals the dispenser opening to reduce cold air loss and prevent warm air or pests entering
• Helps prevent frost buildup and dripping at the dispenser area when functioning correctly
• Works with the dispenser actuator/lever to ensure smooth, timed operation

• One stop door

• Disconnect power to the appliance before starting any repair
• Remove dispenser cover or bezel as needed to access the stop door; retain fasteners and springs
• Handle plastic parts gently to avoid cracking; align hinge pins and test movement before reassembling

This replacement screw fastens refrigerator components securely, restoring a tight, rattle-free fit when original hardware is missing, stripped, or corroded. Use it to secure panels, brackets, or trim and keep parts properly aligned.

• Secures panels, brackets, covers, or trim in place
• Helps maintain correct alignment of components and hardware
• Reduces vibration and rattling caused by loose or missing screws
• Replaces lost, rusted, or stripped screws

• Unplug the refrigerator and turn off water supply if working near water components
• Match thread and length to the removed fastener; hand-start threads to avoid cross-threading
• Tighten snugly; do not overtighten into plastic or thin sheet metal
• Keep track of any spacers or washers reused from the original assembly

This refrigerator door gasket creates an airtight seal around the door to help maintain proper internal temperature and energy efficiency. It replaces a worn or damaged seal to reduce air leaks and help prevent frost buildup. What it does:

• Seals the refrigerator door to keep cold air in and warm air out
• Helps maintain consistent internal temperature for food safety
• Reduces frost and moisture buildup caused by leaking seals
• Can improve energy efficiency if original gasket is cracked or deformed

• One door gasket

• High-level replacement: remove the old gasket, position the new gasket into the door channel, and secure per manufacturer guidance
• Inspect the door flange and mounting channel for debris or damage before installing
• Warm the gasket if needed to make it more flexible for proper seating
• Turn off power to the appliance or follow manufacturer safety instructions before starting work

This shelf module is the replacement shelf component that restores usable storage space and supports items in your refrigerator. It fits into the shelf tracks and provides a stable platform for food and containers. What it does:

• Replaces a broken, cracked, or missing refrigerator shelf module
• Restores a level, secure surface so items sit flat and won't slide
• Helps eliminate rattling, sagging or unstable shelving under load
• Reinstates proper shelf spacing and organization inside the fresh-food compartment

• High-level swap: slide the old shelf module out of the shelf tracks and slide the new module into place; no special tools typically required
• Check that the shelf is fully seated in the tracks and level before loading
• For safety, remove items from nearby shelves before installation and avoid working with wet hands
• If any mounting clips or track hardware are damaged, replace those parts before using the shelf

This set screw secures refrigerator components—most commonly door handles—to their mounting studs. Replacing a missing or stripped screw restores a solid, secure feel and helps prevent loose or wobbly handles.

• Locks the handle to its mounting stud to keep it tight and secure
• Helps resolve a loose, wobbly, sliding, or rattling handle
• Replaces a missing, rounded, or damaged set screw
• Helps maintain proper handle alignment and consistent door operation

• Unplug the appliance or switch off power before servicing
• Ensure the handle is fully seated on the studs before tightening
• Start the screw by hand to avoid cross-threading; then tighten until snug
• Do not overtighten to prevent stripping the screw or handle threads