Parts for Ge GBE20ETEBRCC: Doors Parts

White refrigerator door gasket creates an airtight seal to maintain temperature. Replace if torn, cracked, or not sealing properly. Verify fit with model number.

This stop door is the small dispenser door that helps block the ice/water opening when not in use, keeping cold air in and preventing drafts. It restores proper dispenser sealing and operation for a smooth user experience. What it does:

• Covers and seals the dispenser opening to reduce air loss from the cabinet
• Guides the dispenser flap so it opens and closes cleanly
• Helps prevent warm air intrusion that can cause frost build-up
• Common symptom: dispenser door hangs, sticks, or fails to close fully

• One stop door

• Disconnect power to the appliance before servicing to avoid injury
• Inspect mounting posts and the actuator for damage; replace if worn
• Typically a snap-in replacement; gentle prying may be needed to remove the old door

Replaces broken or missing plug button that covers the hinge pin hole on your refrigerator door. Restores a finished look to exposed hinge areas.

Replacement mounting screw for refrigerator panels, brackets, door handles, and trim. Needed when original hardware is missing, stripped, or corroded.

Replacement fastener for refrigerator door handles. Secures handle to door with durable metal construction. Needed when original is cracked or broken.

Replacement door stop for your refrigerator. Mounts to the cabinet to prevent the door from opening too far. Replace if cracked, broken, or missing.

Replace your refrigerator's broken, cracked, or missing door badge. This decorative emblem installs on the exterior door panel to restore appearance.

Replaces a cracked or worn door hinge thimble on your refrigerator. This small structural component supports the hinge pin for smooth door operation.

Clear dairy door bin and tray for refrigerator door storage. Replaces cracked, broken, or missing dairy compartments. Installs in door shelf area.

Replacement shelf module that restores storage space in your refrigerator. Fits into shelf tracks to support food and containers. Needed when original is cracked, broken, or missing.

Fixed shelf for refrigerator interior storage. Replaces cracked, broken, or damaged shelves. Installs in refrigerator compartment to restore organization.

This set screw secures refrigerator components—most commonly door handles—to their mounting studs. Replacing a missing or stripped screw restores a solid, secure feel and helps prevent loose or wobbly handles.

• Locks the handle to its mounting stud to keep it tight and secure
• Helps resolve a loose, wobbly, sliding, or rattling handle
• Replaces a missing, rounded, or damaged set screw
• Helps maintain proper handle alignment and consistent door operation

• Unplug the appliance or switch off power before servicing
• Ensure the handle is fully seated on the studs before tightening
• Start the screw by hand to avoid cross-threading; then tighten until snug
• Do not overtighten to prevent stripping the screw or handle threads