Parts for Ge GTE22JTNBRWW: Doors Parts

This white plastic door handle replaces a broken or worn handle on compatible refrigerators, restoring a secure grip and a clean, factory look so you can open and close the door confidently.

• Provides the handhold used to open and close the refrigerator door
• Replaces cracked, broken, loose, or missing handles to improve safety and appearance
• Attaches to existing mounting points with model-specific fasteners or set screws
• Helps eliminate wobble or rattling caused by a damaged handle

• Disconnect power at the breaker before starting for safety
• Support the handle while loosening existing fasteners; note their positions and orientation
• Align the new handle; start screws by hand, then tighten evenly without overtightening
• If your model uses trim caps, install them after tightening

This freezer door gasket replaces a worn seal on the freezer door. It restores a tight, continuous seal to keep cold air in, help reduce frost and moisture, and support consistent freezer temperatures and proper door closure.

• Seals the perimeter of the freezer door to limit air leaks and moisture intrusion
• Helps reduce frost buildup and temperature swings in the freezer compartment
• Replaces torn, shrunken, or misshapen gaskets that cause gaps or poor door closure
• Common symptoms: visible cracks or tears, condensation around the door, persistent frost, or the door not sealing flush

• Disconnect power before servicing
• Remove the old gasket and clean the door's gasket channel thoroughly
• To ease installation and relax shipping folds, warm the new gasket with hot water; avoid excessive heat
• Seat corners first, then press evenly around the perimeter; close the door and confirm uniform contact

This freezer door stop is a small plastic bumper that cushions and limits the freezer door's travel to prevent over-extension and reduce slamming. It restores proper door positioning and helps protect the cabinet edge. What it does:

• Acts as a door bumper/stop so the freezer door closes and rests correctly
• Reduces slamming and wear on the door and cabinet edge
• Helps keep the door aligned during normal opening and closing
• Can resolve symptoms like a door that over-rotates, hits the cabinet, or doesn't seat cleanly

• One white freezer door stop

• Typically installs by snapping or sliding into the hinge/cabinet mounting location; verify orientation before pressing into place
• Turn power to the appliance off only if panel removal is required; this part is non-electrical
• Use basic hand tools if needed and avoid forcing the part to prevent breakage

This refrigerator door stop cushions and limits the door swing to prevent over-travel and protect the cabinet and hinge. Durable plastic design restores proper door alignment and reduces slamming for a quieter, safer fridge. What it does

• Replaces a worn or broken door stop to stop the door from swinging too far.
• Helps prevent damage to the cabinet edge and hinge by absorbing impact.
• Reduces door noise and improves door alignment for a consistent seal.
• Commonly used where the original plastic stop is cracked, missing, or worn.

• One refrigerator door stop (white), as shown.

• Basic hand tools typically required; disconnect power only if working near electrical components.
• Keep original fasteners; replace only with like hardware if specified.
• Inspect surrounding hinge and mounting area for wear and replace if necessary.

The Fresh Food Door Gasket is an OEM component specifically designed for GE refrigerators. It creates an airtight seal around the fresh food compartment door, helping to optimize energy efficiency and food freshness. 

The door gasket helps keep cold air in and outside moisture out, maintaining proper temperatures and humidity levels within the refrigerator. It also helps prevent odors from transferring between compartments. 

Symptoms of a bad door gasket include: 

• Increased energy costs from the refrigerator working harder to maintain temperatures
• Faster icing or frost buildup in the freezer
• Items drying out more quickly inside the fresh food compartment  
• Moisture or condensation present around door seals or on internal surfaces

Color: White

This OEM GE replacement part is guaranteed to provide a proper seal and restore effective insulation. It is also compatible with Hotpoint, RCA, and some Kenmore models.

This refrigerator door shelf mounts on the inner door to hold condiments, jars, and bottles. Replacing a cracked or missing shelf restores secure, easy-access storage and helps keep items upright when you open and close the door.

• Snaps into the door's molded rails or end tabs to organize and retain containers
• Restores lost door storage capacity for condiments, jars, and tall bottles
• Common symptoms: cracked or broken plastic, loose or missing shelf, items falling from the door
• Visible damage or worn locking tabs prevent the shelf from staying seated

• Remove the old shelf by lifting up and out; empty contents before removal
• Align the new shelf with the door rails/end tabs and press down until fully seated—do not force
• No tools typically required; handle plastic carefully to avoid cracking
• Install in the same location as the original for proper fit and door clearance

This reversible door plug fills the unused mounting hole when you switch the door swing on your refrigerator. It restores a finished appearance and helps keep air and moisture from entering through the opening.

• Covers the unused door hole created during a door swing reversal
• Helps maintain proper sealing and resists drafts/condensation at the opening
• Restores a clean, finished, factory look to the door
• Common symptoms: missing or cracked plug, exposed hole, cosmetic gap on door edge

• Disconnect power before servicing any door components
• Gently pry out the old plug with a plastic trim tool to avoid scratches
• Align the new plug with the opening and press until fully seated and flush
• Verify the door closes properly and the gasket seals evenly

This kit replaces the mounting hardware that secures a refrigerator/freezer door handle to the door, restoring a solid, safe grip and clean appearance when the original fasteners are missing, damaged, or stripped.

• Provides the correct hardware to attach and secure the door handle
• Helps resolve loose, wobbly, or detached handles
• Replaces missing, damaged, or stripped handle fasteners
• Supports proper handle alignment and feel

• Disconnect power (and water, if applicable) and wear gloves.
• Support the handle while removing old hardware to prevent drops or scratches.
• Start threads by hand to avoid cross-threading; tighten evenly and do not overtighten.
• The handle is secure and the door opens/closes normally.

This plug button is a small snap-in cap used on refrigerators to cover exposed holes on door handles, liners, or trim. It restores a clean, finished look while helping keep dust and moisture out of the cabinet.

• Snaps into a screw or access hole on a handle, liner, or trim panel
• Covers fasteners and gaps for a clean, finished appearance
• Helps block dirt and moisture from open holes
• Typical symptoms: missing cap, broken or loose plug, visible screw hole or cosmetic gap

• Unplug the appliance before servicing and use caution around sharp edges
• Align the plug with the hole and press straight in by hand until fully seated and flush
• For handle screw holes, tighten fasteners first, then install the cap
• Avoid using metal tools on finished surfaces to prevent scratches

The Screw is an OEM replacement part for GE brand refrigerators. It is commonly used to secure panels, handles, shelves, or other parts of the refrigerator.

Causes of a faulty refrigerator screw can include wear and tear over time, damage due to mishandling or over-tightening, or loss of thread integrity. These factors can result in loose or ineffective connections, compromising the stability or functionality of the attached components.

Symptoms of a bad refrigerator screw may include:

• Loose or wobbly panels, handles, or shelves
• Difficulty in attaching or securing components
• Visible damage or breakage of the screw

This OEM GE part can also be used on Hotpoint, RCA, and Kenmore/Sears appliances.