Parts for Ge PCHB920SJ6SS: Drawer Parts

This stainless steel drawer panel restores the exterior look and proper sealing of your appliance drawer. It replaces a scratched, dented or worn front so the drawer sits and operates correctly while matching a stainless finish. What it does:

• Replaces damaged or dented drawer front to improve appearance and drawer alignment
• Helps the drawer close and seal properly when the original panel is bent or loose
• Restores a consistent stainless steel exterior finish
• Useful when scratches, dents or finish wear affect the appliance curb appeal

• One stainless steel drawer panel

• Follow factory service manual for disassembly/reassembly
• Disconnect power to the appliance before servicing if panels are near electrical components
• Handle edges carefully to avoid sharp metal; use proper tools to remove clips/screws
• Only install if this exact part number matches the replacement required for your appliance

This replacement drawer-and-slide assembly restores smooth, stable operation of the lower drawer compartment. Swap out a bent, jammed, or missing assembly to regain easy access and proper alignment.

• Supports and guides the lower drawer as it opens and closes
• Helps the drawer travel smoothly and sit flush when closed
• Replaces damaged components causing sticking, wobbling, or misalignment
• Common symptoms: drawer difficult to move, falls off track, or won't close fully

• Disconnect power and allow the appliance to cool completely; shut off gas supply if applicable.
• Remove the existing drawer; retain any screws, brackets, or clips reused on your model.
• Engage the new assembly fully on the track/slide and verify proper alignment.
• Open and close the drawer several times to ensure smooth travel before returning to service.

The drawer wedge aligns and stabilizes your range's lower storage/warming drawer so it slides smoothly and closes flush. Replacing a worn wedge restores proper fit and helps prevent rattling, scraping, and an uneven drawer gap.

• Keeps the lower drawer centered and level in the cabinet
• Provides a firm stop/spacing for a flush, consistent close
• Reduces side-to-side play and vibration during use
• Common symptoms: crooked drawer, uneven front gap, scraping noises, drawer not closing fully

• Disconnect power and allow the range to cool before servicing
• Remove the lower drawer to access the wedge location
• Note the wedge's orientation; install the new wedge in the same position
• Reinstall the drawer and verify smooth travel and proper alignment