Parts for Craftsman 358791060: Driveshaft / Handle / Shield Parts

All gasoline-powered trimmers must have throttle controls that increase the amount of gasoline flowing into the carburetor. As the amount of fuel increases and the engine revolutions increase, the clutch engages the spool and the trimming line begins to turn. The throttle trigger assembly is quite durable. However, it has several appendages and is required to be under constant pressure when in use. If any of the design parts fail, the trigger unit must be replaced or the trimmer cannot be used. To replace the throttle trigger, open the housing and disconnect the throttle cable from the old trigger. It's easy to see where the new trigger will fit in the housing because the screw holes will line up perfectly with the holes in the new throttle trigger. The throttle cable will fit into one slot on the new trigger and a spring opposite the slot will hold the trigger unit at the proper angle as the housing is replaced. This new throttle trigger is an OEM replacement part, made to the same exacting specification as the original. This throttle control is designed by Craftsman and used on most of their trimmers. It is also compatible with a few other manufacturers' trimmers, including Poulan and Husqvarna.

The handle assist is the handle that is held to steer and control the machine during the trimming process. As the primary touchpoint, the handle has to provide enough comfort while assisting with the machine's function. This handle is designed to be gloves-friendly with a surface rough enough to provide security against slip. Use this as a replacement for a broken, loose, or worn handle. Remember always to hold the handle firmly while operating. This part is designed for use on trimmers or weed cutters made by Craftsman, Weed Eater, Poulan, or Poulan Pro. This is a genuine OEM replacement handle that will provide extra control and less hand fatigue. It is sold individually.

The lower shaft replacement is used for lawn and garden equipment such as trimmers, gas trimmers, and pruners. The shaft is the part that will hold the spool used on these types of equipment. It also connects to the upper shaft.Some of the common problems with the lower drive shaft include worn drive shaft ends, worn bushing, breaks along the metal, or damage to the outer tube. Owners should replace the lower shaft before they use the machine. Continuing to use a trimmer with a broken lower shaft is dangerous and could result in injury or more damage to the machine. The replacement of the lower shaft is relatively simple and will require only a few tools.The replacement part works with certain models of trimmer and pruner from Husqvarna, Weed Eater, and Poulan. This is a genuine OEM replacement part sourced from the manufacturer. The kit is sold individually.

This shield kit is a genuine Husqvarna replacement part for a line trimmers and pole saws. The shield kit, also known as a guard, is a safety precaution to protect the engine from damage and to protect the appliance user from flying debris. The shield also manages the amount of string trimmer line that is spooled out. The shield kit of a line trimmer or pole saw might have to be replaced if there is significant damage to the exterior. While shield kits for line trimmers and pole saws are designed to be durable, the exterior can be gradually worn away by collisions with flying debris and small stones, causing warping and erosion to the plastic material. If the shield kit is damaged, it must be removed and replaced immediately, as it is important for safe use of the appliance. Remember to always wear gloves when handling, repairing, and operating outdoor equipment. This shield kit is compatible with the following brands: Husqvarna, Weed Eater, Craftsman, and Poulan. This part sold individually.