Parts for Weedeater XT600 TYPE 1: Driveshaft / Handle / Shield Parts

Fix unresponsive throttle control on your gas line trimmer with this throttle cable assembly. Connects throttle trigger to engine for speed control.

Replacement D-handle nut for brush cutters and trimmers. Secures the D-handle to the shaft assembly. Replace if stripped, cracked, or missing.

If your trimmer line won't feed or the spool falls off, you likely need a new spool retainer. This part secures the spool in the hub assembly. Quick fix.

Replacement screw for brush cutters, chainsaws, and trimmers. Secures internal components. Replace if stripped, missing, or damaged during repairs.

This trigger, used by Poulan and Weed Eater trimmers and edgers, controls the flow of gasoline into the carburetor so as to increase or decrease the speed of the rotating trimmer twine. The trigger is attached to the trimmer's throttle cable assembly. Though designed and used specifically by Weed Eater and Poulan, more than 85 different gasoline-powered devices use this trigger to regulate gas flow. While made of rugged plastic, the throttle trigger is often susceptible to more wear and tear than almost any other part of the trimmer. It sticks out away from the body of the device and thus is most susceptible. Being constantly squeezed, banged into other pieces of equipment, cement sidewalks, trees, landscaping barriers, and the like, throttle triggers can become bent, broken or irreparably disconnected from the throttle of the yard tool. Replacing the trigger begins with draining fuel from the trimmer's tank, then removing the throttle housing. Remove the throttle cable from the old trigger and install it in the new trigger. Replace the throttle housing. When replacing the trigger, it's best to use a genuine OEM replacement part, like this one, machined to be identical to the original.

Carburetor adaptor mounting screw for trimmers and outdoor power equipment. Replace if stripped, missing, or damaged to secure carb adaptor properly.