Parts for Whirlpool WHD3090GW0: 06 - Drum And Bulkhead Parts

This replacement screen is a protective mesh that helps keep debris out of the appliance's internal flow pathways and components. It restores proper screening to prevent clogging and helps maintain reliable operation. What it does

• Catches lint, rust, scale, and other debris before it reaches valves, pumps, or sensors
• Helps maintain proper water/air flow to reduce service issues caused by blockages
• Protects internal components from premature wear due to particulate contamination
• Can help resolve symptoms like reduced flow, intermittent operation, or debris-related errors

• One replacement screen

• For safety, disconnect power (and water if applicable) before starting work
• Access and removal steps vary by model—refer to your service manual for exact disassembly
• Inspect mating seals or housings; replace any damaged parts to ensure a proper fit

The Belt is an OEM component specifically designed for Whirlpool brand dryers. Located inside the dryer drum, this durable belt rotates the drum and tumbles clothes during cycle operation.  

Symptoms of a bad belt include:

• Clothes taking an excessively long time to dry
• The dryer drum refuses to spin or turn over
• Squealing, grinding, or slipping belt noises 

Causes can range from standard wear and tear over years of use to stretching from overloading. Cracks or splits also weaken belts.

Replacing the belt with a genuine Whirlpool OEM part restores the proper drum rotation needed for efficient drying. This ensures clothes are fluffed and dried thoroughly every cycle. The replacement belt is compatible with dryers from brands including Maytag, KitchenAid, and Jenn-Air.

This genuine OEM screw fastens appliance panels and components to restore secure assembly and stop loose parts. Use it to replace missing or damaged mounting screws so panels, trim, or brackets stay properly secured. What it does

• Secures panels, brackets, trim pieces, or components in place to prevent movement and rattling
• Replaces missing, stripped, or damaged screws that can cause loose or vibrating parts
• Helps maintain correct alignment of panels and assemblies for proper operation

• One screw

• Disconnect power and water before servicing the appliance
• Use the matching driver bit and hand-start threads to avoid cross-threading
• Tighten until snug; do not overtighten to prevent stripping or damage
• If screw strips or won't seat, stop and inspect the hole or use the recommended replacement fastener

This bearing supports the washer tub/drum so it spins smoothly and reduces wobble and noise during cycles. A worn bearing can cause loud rumbling, grinding, or excessive vibration. What it does:

• Provides a low-friction surface for the tub/drum shaft to rotate on
• Keeps the tub/drum aligned to prevent wobble and uneven spin
• Helps reduce noise and vibration caused by worn or damaged bearings
• Supports normal spin and drainage by maintaining proper tub rotation

• One bearing as shown

• Designed for use in compatible front-load washers;
• Replace bearings only when explicitly required; bearing replacement may require disassembly of the tub and special tools
• Disconnect power and water supply before starting repairs; follow manufacturer safety instructions