Parts for Ge GFT14ESSM0WW: Drum Parts

This tapping screw is a self-tapping fastener used to secure panels and components on compatible appliances, restoring secure mounting and preventing loose or vibrating parts. It's a direct replacement for a single factory screw. What it does:

• Threads into sheet metal or plastic mounting points to hold panels, brackets, or small components
• Replaces missing or stripped screws that cause loose panels or rattling
• Helps restore proper alignment and secure connections for controls and covers
• Works where a self-tapping fastener is required instead of a machine screw

• Disconnect power to the appliance before beginning any repair
• Use the correct screwdriver or bit to avoid cam-out and head damage
• Start threading by hand to ensure proper engagement, then tighten until snug — do not over-torque
• Replace only with the exact part to ensure fit and proper fastening

A small replacement housing screw that secures appliance panels and brackets, restoring proper fit and preventing rattles or loose panels. Fits common appliance housings where a short ST4 x 12 self-tapping screw is required. What it does:

• Fastens housing panels, trim, or internal brackets to maintain proper alignment and reduce vibration
• Replaces missing or damaged screws that cause loose or rattling panels
• Works with sheet metal and plastic mounting points designed for ST4 thread size
• Small, low-profile head designed for appliance interiors

• One housing screw (ST4 x 12)

• Disconnect power before servicing the appliance and work on cool surfaces
• Use the correct screwdriver or bit to avoid stripping the head
• Install gently and avoid overtightening to prevent thread or panel damage

Dryer not heating properly or overheating? The outlet thermistor monitors exhaust temperatures to regulate heat levels and prevent damage. Easy fix.

Rubber seal that cushions and secures your dryer light lens. Replace if lens rattles, light flickers, or seal is cracked. Confirm fit with model number.

Captures lint and debris during drying cycles to maintain optimal airflow and prevent vent clogs. Replace if damaged or handle breaks. Verify fit.

If your dryer runs too long or stops before clothes are dry, faulty moisture sensor rods may be the cause. This moderately easy repair restores drying.

Replace your dryer door seal to stop air leaks and maintain efficient drying. Prevents heat loss and lint escape. Verify fit with your model number.

Dryer drum belt transfers power from motor to drum for rotation. Replace if belt is worn, stretched, frayed, or broken causing no tumbling. Confirm fit with your model number.