Parts for CGDE560BW: Electric Dryer Parts

Structural support bracket that mounts inside your dryer assembly. Replace if bracket is cracked, bent, broken, or missing to restore proper alignment.

Tension arm clip for dryers. This small clip secures the idler pulley tension arm in place. Replace if the original clip is broken, missing, or damaged.

This temperature sensing device monitors refrigerator temperature and signals the control board to maintain proper cooling. It helps the appliance respond to temperature changes for more consistent internal climate control. What it does:

• Reads cabinet/evaporator temperature and sends the signal to the control board
• Helps the refrigerator adjust compressor and defrost cycles based on sensed temperature
• Commonly used when the fridge runs too long, doesn't cool evenly, or experiences temperature fluctuations
• Safe, passive electronic sensor — no refrigerant or mechanical moving parts

• One temperature sensing device (thermistor) as shown

• Disconnect power to the appliance before beginning any repair
• Handle the sensor and its connector carefully; avoid pulling on wires
• Verify sensor location and routing against the appliance diagram before installing
• After installation, allow the refrigerator time to stabilize and monitor temperatures for proper operation

Secures the power cord strain relief to your dryer chassis. Replaces lost or damaged mounting screws to restore secure cord attachment and reduce stress.

Sealed bar for dryers. Replace if damaged, cracked, or causing leaks. Verify compatibility with your dryer model number before ordering for proper fit.

Dryer door gasket creates an airtight seal to maintain proper drying temperature. Replace if torn, cracked, or causing heat loss. Verify fit with your model.

Maintains proper tension on dryer linkages to prevent slack and banging. Replace if mechanism is loose or components misalign. Verify fit with your model.

The Lint Filter Support for Dryer is an OEM replacement part for GE electric dryers. The lint filter support holds the lint filter securely at the exhaust vent opening, preventing lint from escaping into the home during the drying cycle. It plays a key role in capturing lint and controlling its removal from circulating air.

Symptoms of a bad lint filter support include: 

• The lint filter not sitting properly at the exhaust vent
• Lint escaping past the filter and potentially blocking the vent tube
• Visible damage like cracks or loose clips 

This GE replacement part is compatible with Hotpoint, RCA, and Kenmore dryer models. 

Support A is a small mounting bracket that secures internal components and keeps assemblies aligned so your appliance operates quietly and reliably. It stabilizes parts to reduce vibration and prevent misalignment that can cause noise or wear. What it does:

• Provides structural support and secures internal assemblies or panels
• Helps keep components aligned to prevent rubbing, rattling, or uneven operation
• Reduces vibration and movement during normal use
• Can help stop intermittent noises or loose-feeling parts related to a failed or missing support

• Disconnect power (unplug appliance or switch off breaker) before service
• Access may require removing outer panels or trim — keep fasteners organized for reassembly
• Use basic hand tools; avoid forcing clips or fasteners to prevent damage