Electrolux Cooktop Parts

Replace the glass window panel in your range oven door when cracked, shattered, or broken. Restores a clear view into the oven and maintains the door's heat barrier.

Mounting spring that secures the heating element in place on your cooktop. Replace if spring is broken, stretched, or missing to properly hold element.

This is a replacement screw used to secure appliance panels and components. It restores proper fastening so panels, trim, or assemblies stay tight and reduce vibration or rattling. What it does

• Fastens panels, brackets, or trim to the appliance chassis
• Helps stop loose or vibrating panels and trim pieces
• Restores proper alignment where a missing or stripped screw causes gaps or movement
• Use when the original screw is missing, damaged, or corroded

• One replacement screw as shown

• Disconnect power to the appliance before starting any repair
• Use the correct screwdriver or bit to avoid stripping the screw head
• Tighten until snug; avoid over-torquing which can strip threads or crack plastic
• Keep removed screws in a safe place; this screw matches the original before installation

This small plastic clip secures the dishwasher drain hose to the pump assembly or discharge fitting, keeping the hose in place and helping prevent leaks or disconnection during operation. What it does:

• Holds the drain hose firmly to the pump or outlet fitting to maintain a watertight connection
• Prevents the hose from slipping free during drain cycles
• Helps stop water leaks and washing chamber flooding caused by a loose hose
• Useful when replacing a cracked or broken retaining clip

• One drain hose retaining clip

• Disconnect power and water supply before accessing the dishwasher lower access area
• Remove the access panel or kickplate to reach the drain hose and pump connection
• Use pliers or a flat tool to remove the old clip and snap the new clip over the hose/fitting until fully seated
• After installation, run a short drain cycle and inspect for leaks; re-secure if necessary

Replace a faulty top burner valve if your cooktop burner won't ignite, flame is too low, or gas won't shut off. Moderate DIY repair in 30-45 minutes.

Power control circuit board for cooktop. Replaces damaged, malfunctioning, or burnt control board. Essential electronic component for burner operation.

Replace your cooktop's internal wire harness if damaged, frayed, or corroded. Connects electrical components inside the cooktop control assembly.

Gas pressure regulator for cooktop burner systems. Mounts to the manifold to control fuel flow. Replace if cracked, leaking, or showing wear.

Converts your natural gas cooktop to liquid propane (LP). Includes orifices and fittings needed for fuel type conversion. Order replacement kit today.

Wiring harness for cooktops. Connects electrical components within the cooktop assembly. Replace if wires are frayed, connectors are damaged, or broken.

Replacement wiring harness for cooktops. Connects electrical components inside the control assembly. Replace if wires are damaged, frayed, or connectors broken.

Flat cooking griddle for gas cooktops. Replace your griddle if it's warped, cracked, or damaged from heavy use. Installs on cooktop surface.

Replace your damaged or missing cooktop griddle. This flat cooking surface installs over burners for preparing pancakes, eggs, and more. Order now.