Electrolux Microwave Bumper, Bushing, Grommet Parts

This replacement cam is the small rotating actuator that engages and controls movement in compatible appliance mechanisms, restoring proper engagement and smooth operation where the original cam has worn or broken. What it does:

• Transfers rotational motion to a latch or linkage to enable proper opening, closing, or dispensing actions
• Ensures consistent engagement and timing of the associated mechanism
• Common symptoms it can fix: intermittent or failed latching, loose or sloppy movement, clicking or grinding noises during operation
• Small, precision part used where alignment and rotation are required

• Disconnect power to the appliance before servicing to avoid shock or injury
• Handle small parts carefully and keep track of fasteners and orientation for correct reassembly
• Installation may require removal of exterior panels or a control assembly; refer to the service manual or diagram for step-by-step guidance

This replacement cam is the small pivot piece that helps a refrigerator door hinge open and close smoothly and keep the door aligned. Installing the cam restores proper hinge movement for a secure, even door fit. What it does:

• Acts as the hinge pivot point to guide door rotation and alignment
• Helps prevent door sagging, binding, or uneven gaps
• Reduces noisy or rough hinge movement caused by a worn cam
• Works with the hinge assembly to maintain proper door sealing

• One cam

• Disconnect power to the appliance or unplug before starting any work
• Support the door while removing hinge fasteners to prevent damage or injury
• Inspect mating hinge surfaces and replace any damaged hardware for best results
• Tighten hinge fasteners to manufacturer torque and check door alignment after installation

This bushing guides and supports a rotating shaft to reduce wear and keep moving parts aligned, restoring smooth, quiet operation. Fits specific Frigidaire appliances—use the OEM part number to fit for your model. What it does

• Supports a rotating shaft or drum to prevent metal-on-metal contact
• Reduces friction and wear that can cause squeaks, grinding, or rough rotation
• Helps maintain proper alignment for consistent appliance performance
• Commonly replaces worn or damaged bushings that allow excessive play

• Disconnect power before servicing and access the affected assembly per your model's service manual
• Remove the worn bushing and any debris; press or tap the new bushing into place squarely
• Inspect mating shaft/surface for scoring or wear; replace or repair if damaged
• Use only OEM-recommended lubricants if specified by the manufacturer; do not assume grease is required

This rubber cushion is a small replacement bumper that reduces vibration, cushions moving parts and helps prevent noise or wear from metal-to-metal contact. It restores quiet, stable operation for the part it supports. What it does:

• Acts as a shock absorber to reduce vibration and rattling
• Protects surfaces and components from direct contact and wear
• Helps maintain proper spacing and alignment for moving assemblies
• Common symptom: noise, vibration, or metal-on-metal contact where a bumper is missing or worn

• One replacement cushion

• Safety first: disconnect power before servicing electrical appliances
• Inspect the mounting area and remove debris before installing the new cushion
• Most cushions press into place; no special tools usually required
• If adhesive or fasteners are present on the old cushion, retain or replace them exactly as found