Electrolux Range / Cooktop / Oven Gas Conv Kit Parts

This replacement water inlet tube routes water from the supply to the refrigerator's dispenser and ice-making components, restoring proper water flow and helping stop leaks or reduced water delivery. What it does:

• Directs incoming water from the household supply line to internal water system components.
• Replaces cracked, split, or clogged tubing that can cause leaks or pooling under/behind the refrigerator.
• Restores normal water flow to the dispenser and ice maker when flow is reduced or intermittent.
• Helps prevent contamination and water damage by providing an intact, leak-free path.

• Turn off water supply and disconnect power before beginning work.
• Use basic hand tools; avoid kinking the tube during installation.
• Inspect O-rings or clamps; replace worn seals if present.
• After installation, restore water and power, then check thoroughly for leaks.

This jet holder assembly secures the water jet/nozzle that directs fill water into the ice maker molds so the ice maker fills cleanly and reliably. It restores proper water direction to help prevent slow fills or misdirected water. What it does:

• Holds and positions the ice maker's water jet/nozzle for accurate water delivery into the ice tray
• Helps ensure consistent fill volume for full, properly formed ice cubes
• Addresses symptoms such as underfilled or uneven ice trays and water spraying or leaking inside the freezer
• Works with the ice maker fill system to keep water aimed at the mold during dispense

• One jet holder assembly

• Disconnect power and shut off the water supply before beginning work
• Handle plastic parts carefully to avoid cracking; use appropriate trim or fastener tools
• Removal may require partial ice maker or shelf disassembly; note alignment for reinstallation
• Test the ice maker's fill function and check for leaks after reinstalling and restoring power/water

This ignitor orifice assembly is the gas orifice and mount used with the oven broil burner igniter to direct gas for reliable ignition. It restores the correct gas path and mounting where the orifice or bracket is damaged or worn. What it does:

• Provides the metered gas path from the manifold to the broil burner igniter to enable ignition.
• Holds the igniter in the correct position for consistent lighting of the broil burner.
• Common symptoms: broil burner won't light, weak or uneven broil flame, or igniter glows/clicks but no flame.
• OEM-designed replacement intended to match original fit and function.

• Turn off electrical power and shut off the gas supply before beginning any work.
• Remove access panels and top/burner components as needed to reach the broil burner area; keep track of screws and small parts.
• Inspect related parts (igniter, burner, mounting hardware) and replace any damaged components for safe operation.