Electrolux Range / Cooktop / Oven Screws, Nuts, Washers

This is a replacement mounting screw used to fasten appliance panels, trim, or components. It restores secure attachment and helps eliminate rattling, loose parts, or misaligned panels for a clean, stable fit. What it does:

• Secures panels, brackets, or trim to the appliance chassis
• Stops vibration-related rattles and movement from loose fasteners
• Keeps components aligned for proper operation and appearance
• Replaces lost or stripped screws to restore factory fit

• Disconnect power and water before beginning any repair
• Use the correct screwdriver or bit to avoid stripping the head
• Thread carefully and do not overtighten; stop when snug to avoid damage
• Inspect surrounding parts and replace as needed

This metal nut secures mating fasteners and small assemblies inside your appliance to restore firm connections and reduce movement. It's a simple replacement for stripped, missing, or damaged mounting hardware. What it does

• Threads onto a matching bolt or stud to hold panels, brackets, or components together
• Restores clamping force to stop loose parts, rattles, or misaligned panels
• Helps maintain electrical and mechanical connections where a threaded fastener is used
• Works wherever the original nut size and thread match the appliance's hardware

• Disconnect power to the appliance before accessing internal components
• Hand-start threads to avoid cross-threading, then tighten securely; do not overtighten
• If the nut fastens an electrical component, ensure connections are secure and re-check after reassembly

This is an authentic OEM replacement bracket locking screw sourced directly from the manufacturer for use on range tops. The stovetop bracket is attached to the stovetop and the stove body. This locking screw is a fully threaded 2.1-inch screw. If this screw becomes loose or rusted, it should be removed and replaced to ensure the stovetop remains fully seated and in good working condition. If the screw is missing, the stovetop bracket will not be fully functional, and the stovetop could become loose. To start, disconnect the power and gas from the unit before replacing the screw on the bracket. Make certain the stove burners are not hot. Remove the burner grates, burner caps, and control knobs. Lift the range top cover. Locate the mounting bracket on the wall unit. If the screw is in the bracket but has rusted, use a screwdriver to remove the missing screw. Set the nut aside for use on the new screw. Install the new screw and the nut from the last screw. Check the bracket alignment before tightening the screw. Tighten the screw to the nut. Lower the stovetop and reconnect the power and gas. This bracket locking screw is a heavy-duty 2.1-inch silver metal screw. It is designed for use on gas ranges manufactured by Frigidaire, Kenmore, Electrolux, and Crosley.