Parts for Briggs & Stratton 96502-3510-01: Engine Parts

This precision-drilled burner orifice is sized for Type 4 butane applications. It meters gas to the burner so flames ignite reliably and burn cleanly when the appliance is configured for butane per the manufacturer's specifications. What it does:

• Regulates gas flow to the burner head for proper flame size and shape
• Type 4 drilling intended for butane gas configurations specified by the manufacturer
• Replaces a missing or stripped orifice during service or gas-type conversion

• 1 burner orifice (Type 4, butane)

• Shut off gas supply and power; allow the appliance to cool before service
• Access the orifice at the burner base/manifold; remove the original with the correct wrench or socket
• Start threads by hand; tighten snugly—avoid overtightening or cross-threading
• After reassembly, leak-check with soapy water and verify flame; gas conversions should be performed following OEM instructions and local codes

This OEM starter grip is a replacement for select Briggs & Stratton engines. The starter rope grip provides the handle that is used to pull the starter rope. When it is pulled, the starter recoil spring engages the flywheel puller, which then causes the flywheel to rotate and starts the rotation of the blade as the engine fires. The starter rope grip is made of durable plastic but it can become damaged or cracked over time. If it is broken, the rope will be unable to be pulled to engage the engine until the part is replaced. This is a genuine starter grip designed to work with a variety of lawn and garden equipment that features a Briggs & Stratton engine with a pull-start. The starter grip is sold in two pieces with the grip and a cap that snaps on once the rope has been tied inside of the handle to secure it in place. The unit is sold individually. This item does not include the rope or any additional parts.

Kit contains total of 8 screws. Approximate size - (Qty.4) #10-32 x 7/16" and (Qty.4) #10-24 x 7/16".

The stop wire is a safety cable device offered on many types of lawn and garden equipment. It is pressed near the upper handle of a device to start it, which lets the blades spin and creates forward motion on equipment that is self-propelled. A stop wire can stretch out over time and will need to be replaced to ensure total safety. If the blade brake control is released and the blades continue to spin for more than a couple of seconds, the wire needs to be replaced.Take the equipment and put it on a flat surface before taking the metal on the stop cable and moving it out of the mower handle. Squeeze the center tabs of the wire with needle-nose pliers and pull the cable end through the bracket. Pull the other end out and then replace it with a new component.This is an authentic OEM replacement part for use with garden equipment engines. It is an individual part that is sourced directly from the manufacturer. This part is compatible with lawnmowers, wood chippers, snowblowers, generators, log splitters, tillers leaf blowers, and pressure washers by Briggs & Stratton, MasterCut, Craftsman, Simplicity, Toro, MTD, Cub Cadet, Lawn-Boy, Murray, and Wheel Horse.