Parts for Craftsman 917388540: Engine / Handle / Housing / Wheels / Bag Parts

This left-hand adaptor bracket secures and aligns a refrigerator column or trim piece so panels sit flush and stable. It helps restore proper door/trim alignment and reduces rattling or visible gaps for a clean, finished look. What it does:

• Secures the refrigerator column/trim to the cabinet frame for proper alignment
• Helps eliminate loose or misaligned trim that can catch or rattle
• Restores intended panel fit and gap spacing after wear or damage
• Useful when replacing damaged or missing mounting hardware

• Designed for appliance service use; use appropriate fasteners as specified by the manufacturer;
• Disconnect power to the appliance if removal requires accessing electrical components

This OEM part is a mulcher mower blade for lawnmowers. The mulcher mower blade is the blade assembly that is used to cut grass in a lawnmower. Over time, the mower blade can deteriorate, becoming dull and ineffective with extended use. If it's been a while since the blade has been replaced, it might be time for a new one. Luckily replacing a mower blade is a relatively simple process. Before beginning, the engine cool and wear work gloves. Disconnect the spark plug wire from the spark plug and remove the fuel tank cap. Place a plastic bag over the fuel tank opening and reinstall the fuel tank cap to keep gasoline from leaking out of the fuel tank cap vent. Tilt the mower back to lift the front wheels and secure the mower handle to a work table to hold the motor steady. Wedge a block of wood between the mower blade and the deck to keep the blade from turning when loosening the blade bolt. Loosen and unthread the blade bolt while holding the cutting blade to keep it from falling. Pull the blade, blade support, and blade bolt off the crankshaft. Make sure to position the new parts on the crankshaft. Hand-tighten the new blade and bolt onto the crankshaft. Use a torque wrench to tighten the blade bolt. This genuine replacement part is compatible with MTD brand lawnmowers.

The Push Button is an OEM component specifically designed for select Bosch dishwashers. Installed on the control panel, its durable silicone-coated switch reliably operates cycles. Smooth travel withstands repeated use while maintaining tactile feedback. 

Causes of push-button failure commonly involve contact degradation from steam exposure. Cracks in the silicone introduce debris requiring periodic replacement.

Causes of a bad push button can involve:

• Unresponsive or stuck on cycles 
• Flashing error codes without cause
• Difficulty changing selected options

Symptoms of a faulty push button include intermittent operations as the controller struggles to interpret signals. Replacement ensures trouble-free functionality.

This OEM Bosch part is also compatible with some Thermador, Blomberg, and Miele dishwashers. Replace to retain convenient cycle selection through heavy usage over the appliance's lifetime.
 

This 30-36V transformer wire harness connects the oven/range transformer to the control circuitry so low-voltage power is delivered where needed. It replaces a damaged or worn harness to restore reliable low-voltage connections. What it does:

• Carries 30–36V low-voltage output from the transformer to control and safety circuits
• Restores power path when frayed, cracked, or corroded wiring causes intermittent or no control power
• Helps fix symptoms such as blank displays, controls not responding, or door lock/clock failures tied to low-voltage power
• Maintains proper connector alignment and secure contacts for consistent voltage delivery

• Disconnect power to the appliance before starting work to avoid shock or damage
• Route the harness clear of heat sources, moving parts, and sharp edges; secure with existing clips or ties