Parts for Craftsman 917378422: Engine / Handles Parts

This replacement control knob restores a secure, easy-to-grip interface for your appliance's control stem so you can select settings reliably and safely. Fits the newer-style control posts used on several Bosch ranges and cooktops. What it does

• Replaces a cracked, stripped, or missing control knob so settings can be selected and held securely.
• Restores tactile control and clear pointer alignment for accurate temperature/speed selection.
• Stops slipping or spinning on the control shaft caused by worn inner splines.
• Helps eliminate intermittent or unintended setting changes from a damaged knob.

• One new-style control knob (single)

• Turn appliance controls off and disconnect power (or gas) before removing/installing knobs.
• Pull the old knob straight off the stem; align the new knob's splines and press fully onto the shaft until seated.
• If knob feels tight or loose, verify correct orientation and that the shaft and inner splines are clean and undamaged.
• If control stem or switch is damaged, replace that component rather than relying on a knob-only fix.

This OEM part is a mulcher mower blade for lawnmowers. The mulcher mower blade is the blade assembly that is used to cut grass in a lawnmower. Over time, the mower blade can deteriorate, becoming dull and ineffective with extended use. If it's been a while since the blade has been replaced, it might be time for a new one. Luckily replacing a mower blade is a relatively simple process. Before beginning, the engine cool and wear work gloves. Disconnect the spark plug wire from the spark plug and remove the fuel tank cap. Place a plastic bag over the fuel tank opening and reinstall the fuel tank cap to keep gasoline from leaking out of the fuel tank cap vent. Tilt the mower back to lift the front wheels and secure the mower handle to a work table to hold the motor steady. Wedge a block of wood between the mower blade and the deck to keep the blade from turning when loosening the blade bolt. Loosen and unthread the blade bolt while holding the cutting blade to keep it from falling. Pull the blade, blade support, and blade bolt off the crankshaft. Make sure to position the new parts on the crankshaft. Hand-tighten the new blade and bolt onto the crankshaft. Use a torque wrench to tighten the blade bolt. This genuine replacement part is compatible with MTD brand lawnmowers.

This left-hand adaptor bracket secures and aligns a refrigerator column or trim piece so panels sit flush and stable. It helps restore proper door/trim alignment and reduces rattling or visible gaps for a clean, finished look. What it does:

• Secures the refrigerator column/trim to the cabinet frame for proper alignment
• Helps eliminate loose or misaligned trim that can catch or rattle
• Restores intended panel fit and gap spacing after wear or damage
• Useful when replacing damaged or missing mounting hardware

• Designed for appliance service use; use appropriate fasteners as specified by the manufacturer;
• Disconnect power to the appliance if removal requires accessing electrical components