Parts for Craftsman 917250810: Engine Parts

This riding lawn mower muffler is a replacement part for mowers that have a bad or damaged muffler. The muffler reduces the amount of exhaust noise that comes from the mower. It is also needed to prevent exhaust sparks from igniting dry leaves, grass, or other debris on the ground. Without a muffler, it could also allow cool air to get into the exhaust valve, which could cause the engine to lose compression. This could mean needing a valve replacement. The muffler on a riding mower can become damaged and have other issues after a couple of seasons. A buildup of soot in the muffler can cause it to be less effective. Additionally, the muffler could develop small holes or cracks that will reduce or eliminate its effectiveness entirely. When the muffler is no longer working properly, or if it has been several seasons, it is a good idea for owners to replace the muffler. This is a genuine OEM part sourced from the manufacturer. It can be used with riding mowers from a range of manufacturers including Ryobi, Husqvarna, Poulan, Craftsman, Jonsered, and Ariens.

This engine pulley is a genuine MTD part, sold individually. This engine pulley can be used as a replacement part in a lawnmower. The purpose of the engine pulley in a lawnmower is to guide the rotational motion of the drive belt within the internal mechanisms of the lawnmower such that the belt can facilitate the rotation of the wheels and the propulsion of the appliance across a variety of surfaces when in use.If the engine pulley has been cracked, scraped, punctured, dented, warped, or eroded to the point that it can no longer serve its function, the engine pulley should be removed and replaced by this genuine OEM replacement part as soon as possible.This OEM part is a genuine replacement that is sold individually and sourced directly from the manufacturer. This engine pulley is compatible with the following outdoor appliance brands: MTD and Craftsman.

This fuel cap is a genuine Husqvarna part, sold individually. This fuel cap can be used as a replacement part in a lawn mower. The purpose of the fuel cap in a lawn mower is to seal the fuel tank.The fuel cap in a lawn mower might have to be replaced if it is damaged and allowing fuel to leak out or debris to reach the fuel tank. This could occur if the fuel cap is punctured, dented, warped, or eroded to the point of exposing the internal mechanisms of the appliance to the outside. If this occurs, the fuel cap should be removed and replaced by this genuine OEM replacement part.This is a genuine OEM replacement sourced directly from the manufacturer. It is sold individually. This fuel cap is compatible with the following outdoor appliance brands: Husqvarna, Craftsman, and Poulan.

This part has been discontinued by the manufacturer and is no longer available.

This no grease mandrel assembly is the part that houses the shaft where the mower blade attaches. It is mounted to the deck of the mower by three bolts, which are sold separately. The mounting holes on the mandrel housing are not threaded, but the bolts used to secure the mandrel to the deck are self-tapping. If the lawnmower is no longer providing an even cut, there may be a problem with the mandrel assembly. A broken or damaged mandrel assembly can severely reduce the mower's cutting performance. Replace it as soon as possible. The mandrel shaft goes through the deck, and the pulleys are attached to them, then the belt that drives the mandrels is placed in the pulleys. A spacer must be installed under the pulley. Failing to use a spacer or installing it on top of the pulley will result in damage to the shaft and pulley. This mandrel assembly is compatible with Ariens, Craftsman, Husqvarna, Poulan, and Weed Eater lawn mower models. It is an OEM part sourced directly from the manufacturer and is sold individually. The mandrel assembly includes a housing, shaft assembly, bearing, and nut only; the pulley/washer and blade bolt/washers are not included.