Parts for Husqvarna YTH18K46-96043021800: Engine Parts

Deck spindle assembly that houses the blade mounting shaft on riding mowers. Bolts to the mower deck. Replace if housing is cracked, worn, or damaged.

Engine belt keeper for riding mowers and lawn tractors. Secures drive belt in proper position during operation. Replace if damaged or missing.

This part is a clutch that is used on lawn tractors. A clutch transfers the power from the engine to the drivetrain and is responsible for engaging the blade.A new clutch may be needed if the lawn tractor will start up but then stalls. If the clutch is sticky or if it operates hard, it may be a good time to replace the clutch. If the engine is revving higher than usual or if there are strange noises coming from the clutch, it is likely that the clutch could be going bad. Remember to wear gloves when operating or performing care and maintenance on any outdoor power equipment.This clutch is a genuine Husqvarna part. It is sold individually. This particular clutch is compatible with lawn tractors that are manufactured by Husqvarna, Jonsered, Craftsman, and Murray.

Front fuel tank assembly with cap for riding mowers and lawn tractors. Replace your cracked, leaking, or damaged fuel tank to restore safe fuel storage.

This genuine Husqvarna fuel cap provides cover and protection to the hole into which engine oil is dispensed on certain lawn mowers, lawn tractors, and snowblowers. This fuel cap should remain closed when the appliance at hand is not in use in order to prevent leakage.If the engine of a small engine appliance is suffering from frequent leakages, there could be damage in the fuel cap that is causing the leaks. A fuel cap could also become misplaced. If the cap is broken or lost, it must be replaced immediately before using the small engine appliance again. Remember to always wear gloves when handling, repairing, and operating outdoor equipment. This fuel cap is compatible with the following brands: Husqvarna, Poulan, Ariens, and Craftsman. This part is sold individually.

Fix poor engine response or speed control issues with this riding mower throttle control. Restores precise engine speed adjustment for smooth operation.

Choke control cable for riding mowers and lawn tractors. Connects engine choke to control panel. Replace if cable is frayed, broken, or stuck.

Exhaust tube muffler for riding mowers and lawn tractors. Replaces cracked, rusted, or broken exhaust tubes that need replacement due to wear or damage.

Left-hand exhaust tube muffler for riding mowers and lawn tractors. Replaces cracked, rusted, or damaged exhaust tubes that leak or have separated.

Oil drain tube assembly for lawn tractors and riding mowers. Installs under engine for oil changes. Replace if cracked, leaking, or missing clips.

Hex head screw for lawn tractors, riding mowers, and snowblowers. Replaces lost, stripped, or corroded fasteners in various assembly locations.

Fastener screw for riding mowers and lawn tractors. Secures components and panels. Replace if stripped, rusted, broken, or missing during repairs.

This fastening hardware secures various components throughout the lawn tractor's frame, engine, and deck assemblies. Replace when bolts become stripped, corroded, or loose, causing rattling sounds or unstable attachment of parts.