Parts for Bosch B10CB80NVW/01: Evap Parts

This replacement fan circulates air within the appliance for cooling and ventilation, helping protect internal components and maintain proper operation. Replace a damaged or seized fan to restore quiet, reliable airflow.

• Moves air to dissipate heat and vent the appliance, protecting controls and electronics
• Worn or broken blades can cause rattling, scraping, or grinding noises
• Poor or no airflow may lead to hot surfaces or overheat/shutoff symptoms
• A fan that won't start, stalls, or wobbles indicates replacement is needed

• Disconnect power to the appliance before servicing
• Access the fan location; remove necessary panels
• Note the original orientation/positioning and transfer any hardware or brackets as needed
• After installation, spin the fan by hand to ensure free movement and clearances before reassembly and test

A thermal fuse that cuts power when temperatures exceed safe limits to protect the appliance and wiring. Installs in the appliance's heater/thermal circuit to stop operation during overheating. What it does:

• Opens the circuit if internal temperature rises above the fuse rating to prevent fire or damage
• Stops heating components when a fault causes excessive heat
• Commonly associated with no-heat or a unit that won't start after an overheat event
• Helps protect control boards and wiring from thermal failure

• One thermal fuse

• Disconnect power (unplug or switch off the breaker) before attempting service
• Replace only with the exact part number; match terminals and mounting location
• Handle carefully and avoid bending terminals; ensure secure electrical connections
• If overheating occurred, verify/repair root cause before reinstalling

This replacement fixture assembly restores the original mounting/support function for the listed part number, helping repair loose or damaged hardware so the appliance component sits securely and operates as intended. What it does:

• Provides the proper mounting or support for the associated component to prevent movement or rattling
• Restores alignment so doors, panels or internal parts engage correctly
• Replaces cracked, broken or worn fixture pieces that cause loose fittings or noise
• Helps maintain original fit and function when the factory part is damaged

• Disconnect power and, if applicable, water supply before starting any repair
• Keep all mounting hardware; inspect screws/clips and replace if worn
• Test the repaired component for secure fit and normal operation before returning the appliance to service

This NTC temperature sensor detects internal appliance temperature and sends readings to the control board so the unit can regulate cooling. It's a direct-replacement sensing element used in refrigerators/freezers and other temperature-controlled compartments. What it does:

• Measures compartment temperature using an NTC thermistor element
• Sends temperature data to the control board for accurate cooling cycles
• Often replaced when temperature reads incorrect, cooling is inconsistent, or the compressor runs excessively
• Can resolve intermittent temperature-related error codes tied to the sensor circuit

• Always unplug the appliance or switch off power at the breaker before starting work
• Handle the sensor and wiring harness carefully to avoid damage; secure connectors fully
• Replace only if confirmed compatible with your model and symptoms;