Parts for Lg LF29S8365S: Exploded View & Replacement Parts List Parts

This roller assembly supports and helps the dryer drum turn smoothly, reducing noise and wear for consistent drying. Replace a worn roller to restore steady drum rotation and reduce squeaks or rubbing sounds. What it does:

• Supports the drum while it spins to maintain proper alignment
• Reduces friction and prevents uneven drum movement or scraping
• Commonly replaces worn or noisy rollers that cause squealing or thumping
• Helps prevent premature wear to the drum and support shafts

• One roller assembly

• Disconnect power (and gas supply, if applicable) before starting any repairs
• Access typically requires opening the dryer cabinet; basic hand tools are usually sufficient
• Inspect other drum support components (other rollers, axles, and bearing pads) and replace if worn

This freezer door foam assembly restores the insulating core behind the door gasket to help maintain cold temperatures and improve seal performance. It's a direct-fit internal foam component used where the door's insulation is damaged or compressed. What it does

• Replaces the insulating foam core inside the freezer door to reduce air transfer and heat gain.
• Helps restore proper door sealing where interior foam has deteriorated, reducing frost buildup and excessive run time.
• Supports the door gasket to improve contact and maintain consistent cabinet temperature.
• Prevents cold leakage that can lead to food thawing or icy buildup around the door.

• One freezer door foam assembly.

• Unplug the appliance or disconnect power before starting any repair.
• Typically installed behind the door inner panel; door panel removal and trim clips or screws may be required.
• Handle carefully to avoid tearing the foam; verify proper alignment before reassembling the door.
• If adhesive or sealant is present, remove old residue and replace with OEM-recommended adhesive or fasteners as needed.

This slide rail is a replacement drawer guide that restores smooth, stable drawer movement and helps prevent binding or sagging. Designed to match the OEM fit so drawers open and close reliably. What it does:

• Guides and supports the appliance drawer for smooth sliding motion
• Replaces worn or damaged rails that cause sticking, sticking intermittently, or uneven travel
• Helps prevent drawer tilt or sag when loaded
• Restores proper alignment for secure closing

• Disconnect power to the appliance before beginning any work
• Remove the drawer per your model's service instructions to access the rail
• Use basic hand tools (screwdriver/driver) to remove and replace the rail; keep fasteners for reuse
• Align the rail carefully, slide the drawer to test operation, and verify smooth movement before returning the appliance to service

Supports and guides refrigerator drawers for smooth gliding. Replace when worn, broken, or causing binding. Confirm fit with your model number.

Ice maker not ejecting cubes or making grinding noises? This drive gear transfers motor power to rotate the ejector. Easy DIY fix in 15 minutes.

Interior light won't turn off when door closes? This refrigerator door switch cover protects and aligns the switch for proper operation. Simple DIY fix.