Parts for Bosch HBN442AUC: Fascia Panel Parts

This is the outer mounting frame used to support and align the appliance door and front assembly for a secure fit and proper operation. Replaces a damaged or bent frame to restore correct door alignment and appearance. What it does

• Provides structural support for the door/front panel and mounting points for hinges and trim
• Helps maintain proper door alignment and prevents rubbing or binding during opening/closing
• Commonly replaced when the frame is bent, cracked, or visibly damaged
• Can resolve fit-and-seal issues caused by a warped or broken front frame

• One outer mounting frame

• Disconnect power and water before beginning any repair
• Remove surrounding trim or inner panel to access mounting screws and hinge attachments
• Handle any attached glass or trim pieces carefully to avoid breakage
• Tighten hardware to manufacturer torque where specified and test door alignment after installation

A replacement white control knob that restores user control and the appliance's front-panel appearance. Fits the original control shaft for straightforward replacement and re-enables manual setting selection. What it does:

• Replaces a cracked, stripped, or missing control knob so you can change settings again
• Restores the knob indicator used to select temperature or cycle positions
• Provides the correct fit and rotation for the appliance's existing control shaft
• Helps eliminate slipping or incomplete engagement caused by a damaged knob

• Disconnect power to the appliance before beginning any work.
• Pull the old knob straight off the shaft; align the new knob's slot with the shaft and push on until fully seated.
• Do not force; if the knob does not seat easily, confirm shaft type and orientation to avoid damage.
• If the control shaft is damaged or loose, additional repairs may be required.

M4.2 x 9.5mm mounting screw for wall ovens. Secures interior panels, brackets, and components. Replace if stripped, missing, or damaged during repairs.

This is a hose used in an oven or range to route steam, water, or air between internal components. It connects to fittings within the appliance and helps maintain proper fluid or vapor flow during operation. Replace this hose if it is cracked, kinked, leaking, or has become brittle with age, which can cause water leaks or reduced performance.

Circuit board spacer for wall ovens. Maintains proper spacing between electronic control boards. Replace if broken, cracked, or missing to prevent board damage.