Parts for Lg 51862: Freezer Compartment Parts

This restrainer is a small retaining clip that helps secure moving or removable components in place, reducing rattles and keeping parts aligned for reliable operation. It's a simple replacement for worn or broken clips. What it does:

• Holds a cover, panel, or door-related component in proper position to prevent shifting
• Reduces noise caused by loose or vibrating parts
• Restores original fit where a broken or missing clip allows movement
• Simple mechanical function — no electrical connections or calibration

• One restrainer

• Disconnect power (and water if applicable) before beginning repairs
• Inspect surrounding mounting points for damage; replace any broken tabs or fasteners
• Typically installs with basic hand tools; align clip and press or snap into place until secure

Replace a cracked or broken refrigerator drawer tray assembly. This storage tray installs inside your fridge to organize food and beverages securely.

Fix excessive vibration and loud noises from your refrigerator with this motor bracket. Secures the motor to the chassis, preventing misalignment issues.

Tube cover for refrigerator water lines. Replaces cracked, broken, or missing covers that protect tubing connections. Installs over exposed tubes.

Plastic cap that covers the air duct opening in your refrigerator. Replace if cracked, broken, or missing to restore proper airflow channel coverage.

Refrigerator tray cover assembly that sits above the storage tray in your side-by-side fridge. Replace if cracked, broken, or missing for proper fit.

Refrigerator running loud or fan exposed? This fan grille assembly protects the fan motor, directs airflow, and reduces noise. Simple snap-in install.

Upper door hinge assembly for side-by-side refrigerators. Secures the top of the door to the cabinet. Replace if cracked, broken, or worn causing misalignment.

Lower hinge assembly for refrigerator doors. Mounts at the bottom of the door to support weight and allow smooth opening. Replace if cracked or worn.

Drain tray assembly for side-by-side refrigerators. Collects defrost water beneath the appliance. Replace if cracked, warped, or missing.

Freezer not cooling or icing up? This evaporator coil and housing assembly absorbs heat and restores proper cold-air circulation in your refrigerator.

If your refrigerator is noisy or not cooling properly, the fan assembly may be worn. This part circulates air to maintain even temperatures throughout.

Replaces damaged, cracked, or missing outer cover panel on your refrigerator. Restores finished appearance and protects internal components.

Fix no water dispensing or leaking water lines with this inlet valve assembly. Controls water flow to your refrigerator. Straightforward DIY repair.

This hinge lever mounts on the refrigerator door hinge to guide door movement and closure, helping the door seal properly. Replacing a worn or broken lever restores smooth operation and consistent sealing.

• Guides hinge motion so the door opens and closes smoothly
• Helps maintain door alignment for a reliable gasket seal
• Replace if the lever is visibly cracked, worn, or deformed

• Disconnect power and support the door to prevent injury or damage
• Remove the hinge cover and fasteners; note the lever's orientation before removal
• Install the new lever in the same position and reassemble the hinge components
• Adjust hinge per model procedures if needed

This is a rubber or elastomer damper that supports and isolates the evaporator fan motor inside the refrigerator. It absorbs vibration from the motor to reduce noise during normal operation. Replace this part if you hear excessive buzzing, rattling, or vibration coming from the freezer section, which often indicates the damper has hardened or deteriorated.