Parts for Ge GTY25SBBJRSS: 01 - Freezer Door Parts

This large door handle assembly replaces a worn, cracked, or broken refrigerator door handle to restore a secure grip and original appearance. It fits the factory mount points for a direct, like-for-like replacement. What it does:

• Provides a sturdy, finished handle for opening and closing the refrigerator door
• Replaces cracked, loose, or cosmetically damaged handles
• Restores original fit and alignment at the door mounting points
• Helps prevent accidental slips or difficulty opening the door caused by broken hardware

• Disconnect power to the appliance before starting work to avoid electrical hazard
• Use basic hand tools; support the door and handle during removal and installation to prevent damage
• Keep mounting screws and trim pieces organized for reassembly; do not overtighten fasteners
• If the handle has a finish or painted surface, handle carefully to avoid scratches

Stainless steel fastener that secures your refrigerator door handle to the door assembly. Replace when original is stripped, missing, or damaged.

Black plastic door hinge thimble bushing for refrigerators. Replaces worn, cracked, or missing thimbles that support door hinge pins and alignment.

Bottom door cap cover for refrigerators. Replaces cracked, broken, or missing caps on the lower door edge. Restores finished appearance to door.

Black door bottom cap for refrigerators. Covers and protects the lower edge of the door. Replace if cracked, broken, or missing for a finished look.

Black corner top cap for refrigerators. Covers the top corner joint of the cabinet. Replace this cosmetic cap if yours is cracked, broken, or missing.

Replacement nameplate lens for your refrigerator. This clear plastic cover installs over the model information plate on the exterior. Order when cracked or missing.

A replacement reversible plug door that covers and protects the appliance power inlet while letting the cord exit left or right for tidy cord routing. Restores a clean back panel appearance and helps keep the power connection protected from debris. What it does:

• Covers the power inlet opening to protect the plug and inlet from dust and debris.
• Reversible design lets you route the power cord to either side to fit against the wall.
• Helps keep the cord tucked close to the appliance so the unit can sit flush with cabinetry or walls.
• Replace when the door is cracked, broken, missing, or no longer holds the plug securely.

• Always unplug the appliance before starting any repair or inspection.
• May require access to the rear panel; check your owner's manual for disassembly steps.
• Check orientation before finalizing installation to ensure correct left/right cord routing.

Replacement mounting screw for refrigerator panels, brackets, door handles, and trim. Needed when original hardware is missing, stripped, or corroded.

Black plastic plug button insert for refrigerator cabinet or door panels. Replaces cracked, missing, or worn decorative plugs that cover mounting holes.

This plug cover is a small protective cap that shields an appliance's power or wiring plug/terminal area from dust and accidental contact. It helps keep connections clean and reduces the risk of debris buildup. What it does

• Covers and protects an exposed appliance plug or terminal connection
• Helps prevent dust, dirt and small debris from entering the plug area
• Reduces risk of accidental contact with terminals while appliance is serviced or idle
• Commonly used when a cord or plug is not in use or during maintenance

• No special tools required; push the cover firmly into place over the plug or terminal
• Ensure the appliance is powered off and unplugged before servicing nearby components
• Inspect the cover for damage and replace if cracked or deformed
• Not intended to alter electrical connections or provide waterproofing; use only as a protective cap