Parts for Ge TBE21JASRRWH: 01 - Freezer Door Parts

Reinforces and stabilizes your refrigerator door handle assembly. Replace this stiffener if it's cracked, broken, or missing to restore proper support.

Assembly screw kit for refrigerators. Secures handles, shelf tracks, door hinges, and interior panels. Replace missing, stripped, or lost screws.

White plastic end cap for refrigerator door shelf bars. Snaps onto bar ends to hold shelves securely in place. Replace cracked, broken, or missing caps.

Seals freezer door to keep cold air in and warm air out. Replace if torn, cracked, or not sealing properly. Verify fit with your model number.

This push-button plug insulates and seals a control panel push-button, helping keep the button stable and protecting the switch from moisture and debris. Fits where a small plastic button bushing or insulator is needed on the control panel. What it does:

• Provides an insulating bushing for a control panel push-button or switch
• Helps hold the button aligned and reduces wobble or uneven operation
• Shields the switch contacts from moisture and dirt that can cause intermittent operation
• Commonly replaced when the button is loose, damaged, cracked, or missing

• Disconnect power to the appliance before removing the control panel or working near electrical components
• Remove the control panel or trim; use appropriate tools to avoid cracking surrounding plastic
• Install the plug gently; do not force or use excessive heat

Hardware kit with 12 mounting screws for refrigerator assembly and component installation. Replace missing, stripped, or corroded screws during repairs.

Plastic end cap that covers exposed trim edges and screw openings on refrigerator handles and trim. Replace if cracked, broken, or missing for a finished look.

2 wire insulator.

Replacement screw for refrigerators. Secures handles, panels, and internal components. Order if yours is missing, stripped, or lost during repairs.

Fix frost buildup in your refrigerator with this heater insulation assembly. Restores proper defrost cycle performance. Moderate DIY install.

This right-side cover duct assembly directs air and protects internal components in the refrigerator cabinet, restoring proper airflow and finish. A direct-fit replacement that helps maintain even cooling and prevents drafts or noise from loose ducting. What it does

• Channels cold air from the evaporator to the refrigerator compartment for consistent temperature distribution.
• Covers and protects evaporator area components from debris and accidental contact.
• Helps reduce airflow noise caused by damaged or missing ducting.
• Supports proper door closure and interior trim alignment when installed correctly.

• One right-side cover duct assembly.

• Remove power to the appliance before attempting any repairs to avoid shock or injury.
• Handle plastic components carefully to avoid cracking; use proper tools to remove fasteners.
• Verify part orientation and secure all clips/fasteners; misaligned ducts can affect cooling performance.

Size: 8-32 t. Includes 12 screws.