Parts for Ge TPS24BICABS: 01 - Freezer Door Parts

Size: 10-32 GXTT FLP.595 S

Includes 12 screws. Size: 8-18 ab.

Package of 12

Size: 10-16 ab.

This screw secures panels and components on compatible GE appliances to restore proper fit and reduce vibration. Use it to replace a lost or stripped fastener and keep covers and brackets held firmly in place. What it does:

• Fastens access panels, trim pieces, or internal brackets to maintain proper alignment
• Stops rattling or vibration caused by missing or loose screws
• Restores secure mounting after repair or parts replacement
• Works where the appliance requires a short sheet-metal or machine screw for fastening

• Disconnect power to the appliance before removing panels or performing repairs.
• Use the correct screwdriver or bit to avoid stripping the head.
• Hand-start the screw to ensure proper threading; tighten until snug but avoid over-torquing.

This is a replacement 10-32 x 1 machine screw used to fasten appliance components. It restores secure mounting of panels, brackets and hardware so parts stay aligned and vibration or rattling is reduced. What it does:

• Secures panels, brackets, housings and small components to the appliance frame
• Keeps control boards, motors or assemblies held firmly in place
• Prevents loose parts that can cause vibration, noise or intermittent connections
• Matches the OEM thread and length for proper fit when replacing a worn or missing screw

• Disconnect power before working inside the appliance
• Use the correct 10-32 driver or bit to avoid stripping the head
• Thread into the original hole and tighten snugly; avoid over-torquing
• Replace with the same size and thread type to ensure proper fit and safety

This top trim piece finishes and protects the upper edge of the freezer door, restoring a clean factory appearance and helping keep the door seal area covered. Fits the freezer door top on compatible GE refrigerators. What it does:

• Covers and protects the top edge of the freezer door from dings, scratches and wear
• Restores a factory-finish appearance to the freezer door front
• Helps keep the door seal area neat and reduces gaps where debris can collect
• Useful when original trim is cracked, bent or cosmetically damaged

• Install with the refrigerator door closed and supported; remove and reinstall trim per OEM instructions
• Use appropriate fasteners/clips as required — replace any damaged clips for a secure fit
• Disconnect power only if required by your model for access; otherwise follow basic safety and use gloves to avoid sharp edges