Parts for Maytag 5GBL22PRYA0: 07 - Freezer Door Parts

Color: Stainless

The Grey Door Gasket is an OEM replacement part for Whirlpool refrigerators. It is a sealing strip that sits snugly around the perimeter of the door. The gasket plays an important role in preventing warm air and moisture from entering the refrigerator interior when the door is closed.

Causes of a bad gasket can include regular use over multiple years, damage from over-tightening the door or bumping/impacting the door seal, or deterioration of the sealing material over time.

Symptoms of a bad gasket include:

• Excessive frost or ice buildup inside the refrigerator
• Higher than normal energy usage
• Warm or humid air leaks into the fresh food compartment

This OEM Whirlpool part is also compatible with Maytag, KitchenAid, Jenn-Air, Amana, Magic Chef, Admiral, Norge, Roper, and some Kenmore models.

Color: For white, black and bisque models.

This stop-door is a small replacement door stop that helps control how the appliance door closes and rests, restoring proper door movement and preventing over-travel or binding. What it does:

• Cushions and limits the door's travel to prevent slamming or over-rotation.
• Helps the door align and latch correctly when closing.
• Can reduce door sag or rubbing caused by a worn/missing stop.
• Addresses symptoms such as a door that closes too far, hangs unevenly, or doesn't sit flush.

• High-level, two-person recommended for larger doors; support the door before removing fasteners.
• Disconnect power (and water if applicable) and follow manufacturer safety guidance before servicing.
• Use appropriate hand tools; inspect adjacent hinges and fasteners and replace if damaged.

This replacement screw secures panels, brackets, and components inside appliances. Replacing a missing or stripped fastener restores a snug, rattle-free fit using the correct #8-18 thread and 5/8-inch length.

• Fastens covers, trims, brackets, and internal parts to the cabinet/frame
• Used wherever a #8-18 x 5/8 screw is specified
• Replace if the original is missing, corroded, stripped, or will not tighten
• Symptoms: loose or rattling panels, gaps, or hardware that backs out

• Disconnect power; shut off gas/water before servicing
• Match thread and length; start by hand to avoid cross-threading
• Use the correct driver bit and tighten snugly—do not overtighten
• Inspect and replace damaged clips or tabs before securing