Parts for HFC3501ACW: Freezer Parts

This drain plug seals the tub drain opening to prevent water from leaking or pooling beneath the appliance. Replacing a damaged plug helps keep the tub watertight during fill and drain cycles. What it does:

• Seals the tub drain opening to stop leaks and water under the appliance.
• Commonly replaced when you see water pooling beneath the unit or a cracked/missing plug.
• Restores a watertight seal after tub or pump service.
• Small, simple part — inspect for cracks, splits, or hardening that cause leaks.

• Disconnect power and turn off the water supply before servicing the appliance.
• Drain any remaining water from the tub or pump to avoid spills when replacing the plug.
• Remove the old plug and install the new plug, ensuring it is fully seated and sealed; check for leaks after restoring power/water.

This exterior drain plug seals the washer's drain opening to prevent leaks and contain water in the tub during operation. It provides a simple replacement to restore a watertight seal at the appliance drain area. What it does:

• Seals the drain opening to help prevent water leaks from the tub or drain housing
• Helps maintain proper drainage by keeping debris out of the drain path
• Can stop visible water weeping or puddling near the base of the washer
• Replaces a cracked, worn or missing exterior drain plug to restore normal operation

• One exterior drain plug

• Disconnect power to the appliance and turn off water supply before starting any work
• Remove the appropriate access panel or lower kick plate to reach the drain opening
• Press or thread the plug into the drain opening as designed; snug by hand and avoid over-tightening
• Inspect the surrounding seal area and replace any damaged gaskets or housings if present; test for leaks after reinstalling panels and restoring power/water

This replacement knob thermostat provides the user interface for adjusting oven or range temperature settings, restoring precise control and reliable temperature selection. It fits the original control shaft and matches factory form and function. What it does:

• Replaces a worn or damaged temperature control knob so you can set cooking temperatures accurately
• Restores responsive temperature adjustments when the control is hard to turn or slipping
• Helps address symptoms such as knob not turning, loose or broken knob, or inability to change temperature settings
• Matches factory fit to align with the control shaft and detents for secure operation

• Always disconnect power to the appliance before beginning any repair
• Typical installation requires removing the control panel or retaining clip/screw; keep small hardware secure

Color: white. Measures about 9 inches wide by 7-1/2 inches high by 17 inches deep.