Parts for Ge GTS18DBMARCC: 02 - Freezer Section Parts

Plastic plug button that covers screw holes on the freezer evaporator cover. Replace if cracked, broken, or missing during evaporator access or repair.

Protective cover for the icemaker receptacle in your freezer compartment. Prevents moisture from entering the socket when an icemaker is not installed.

Stainless steel hex washer head screw secures dishwasher panels, trim, and internal components. Replace when stripped, corroded, or missing.

Secures and seals water line connections in your refrigerator's dispensing system. Replace if leaking or loose to prevent water damage. Confirm fit.

This plug housing switch is the molded connector that secures and protects the appliance power cord where it plugs into the appliance. It restores a stable, insulated connection and helps prevent arcing or intermittent power. What it does:

• Houses and secures the power cord terminals to maintain a reliable electrical connection
• Protects exposed terminals from moisture and debris to reduce shorting or arcing risk
• Replaces cracked, melted, or loose housings that can cause intermittent power or appliance failure
• Commonly used when the appliance won't power on or power is intermittent at the cord connection

• One plug housing switch

• Disconnect power at the breaker or unplug the appliance before servicing
• Inspect the power cord and terminal screws for damage; replace cord if terminals are burned or wires are compromised
• Hand tools typically required; ensure terminals are fully seated and screws tightened to secure the cord

Refrigerator not cooling but freezer works? A failed evaporator fan motor stops cold air circulation. DIY-friendly repair with basic tools in 30-60 minutes.

Freezer fan loud or not spinning? This evaporator fan blade circulates cold air over the coils. DIY-friendly repair with our video guide.

Rubber bumper that cushions and mounts the evaporator fan motor assembly. Replace if cracked, deteriorated, or missing to reduce vibration and noise.

Rubber grommet cushions and stabilizes the evaporator fan motor in your refrigerator. Replace if cracked, worn, or missing to reduce vibrations and noise.

Fix a warm fridge or freezer ice buildup. This defrost heater melts frost on evaporator coils to restore cooling. Moderate DIY repair, 1-2 hours.

Conductor wire transfers heat from the defrost heater to the drain opening, preventing freeze-ups. Replace if damaged, corroded, or missing to maintain proper drainage in your freezer.

Fixes warm fridge with cold freezer caused by frosted evaporator coils. This defrost thermostat regulates defrost cycles. Moderate DIY repair, 1-2 hours.

Secures and positions the heating element in your microwave. Replace if the original holder is cracked, broken, or damaged to restore stable element mounting.

Drain trough that channels defrost water to the drain pan in your top-mount refrigerator. Replace if cracked, warped, or missing to prevent leaks.

Replacement screw secures panels, brackets, and trim inside your oven or range. Restores tight fit when original hardware is missing, stripped, or damaged.

Replacement mounting screw for securing panels, trim, and internal brackets. Needed when original fasteners are missing, stripped, or damaged.

Replacement mounting screws for dishwashers. Secure panels, racks, and internal components. Order this 12-piece kit if originals are stripped or missing.