Parts for Ge PFSF6PKWABB: 03 - Freezer Section Parts

Replace your refrigerator water filter every 6 months to maintain clean water and ice. Removes contaminants for fresh taste. Easy DIY install in minutes.

This temperature sensor monitors internal refrigerator temperatures and relays them to the control, helping the unit maintain consistent cooling. Replacing a failed sensor restores accurate temperature regulation and more reliable operation. What it does

Replaces the freezer evaporator defrost heater to melt frost and keep the evaporator fins clear during the defrost cycle, helping restore proper airflow and more consistent cooling when frost or ice builds up. What it does:

• Heats the evaporator fins during the defrost cycle to remove accumulated frost and ice.
• Common symptom: visible frost or ice buildup on evaporator coils or freezer walls.
• Other symptoms: reduced cooling performance or fluctuating/freezer temperatures that may indicate a defrost failure.
• Works as the heating element in the refrigerator's defrost system to prevent recurring frost accumulation.

What's included: One defrost heater. Install notes:

• Always disconnect power to the appliance before servicing to avoid shock or injury.
• Heater mounts near or on the freezer evaporator; access typically requires removing interior panels and the evaporator cover.
• Inspect wiring and connectors for damage; test the old heater for continuity before replacement.

Secures the temperature sensor in your refrigerator's freezer compartment. Replace if the holder is cracked, broken, or missing to properly mount the sensor.

A small mounting clip that secures a plastic housing or cover to the appliance frame, keeping panels aligned and internal components protected. Replaces a worn or broken clip to restore proper fit and reduce rattles. What it does:

• Secures a housing or access cover to the appliance cabinet so panels stay aligned
• Keeps wiring and internal components covered and protected from debris
• Stops covers from sagging, rattling or falling off due to a broken clip
• Helps maintain normal airflow paths and panel fit where applicable

• Always disconnect power to the appliance before inspecting or servicing panels
• Typically fastens with snap-in engagement or a small screw; basic hand tools may be required
• Handle plastic panels and clips gently to avoid cracking; replace any damaged adjacent fasteners

Replacement light cover lens for your refrigerator. Protects the bulb and diffuses light. Replace if cracked, yellowed, or broken to restore proper lighting.

The Light Bulb (40W) is an OEM component for GE refrigerators. As an essential task lamp, it illuminates the interior of the refrigerator and freezer compartments. 

All light bulbs will eventually burn out with consistent use over many yea

Fix uneven cooling or frost buildup in your refrigerator. This evaporator fan assembly circulates cold air across the coil for consistent temperatures.

Self-tapping screw fastens appliance panels, brackets, and trim by cutting its own thread. Replace missing, stripped, or broken screws during repairs.

Tapping screw for dryer or refrigerator assembly. Replace this fastener if cracked, stripped, or missing during panel or component installation.

Plastic housing that covers and protects the evaporator fan in the freezer section. Replace if cracked, broken, or missing to restore proper airflow.

Is your refrigerator not cooling properly or making unusual noises? A faulty evaporator fan blade disrupts airflow. Direct replacement part restores cooling.

Retaining spring secures the fan blade to the motor shaft in your refrigerator. Replace if spring is broken, missing, or loses tension.

Fix warm fridge or noisy freezer sounds with this evaporator fan motor. Circulates cold air across coils to restore proper cooling and quiet operation.

Fix a refrigerator that's icing up or not cooling evenly. This evaporator fan motor circulates cold air across coils to restore consistent temperatures.